GB/T 7165.4-2008 Equipment for continuous monitoring of radioactivity in gaseous effluents.Part 4:Specific requirements for radioactive iodine monitors (English Version)
This part of GB/T 7165 applies to equipment for simultaneous, delayed or sequential measurement of all forms of radioactive iodine. When sampling the effluent for measurement, the iodine attached to the aerosol is typically collected by a pre-filter and analyzed separately in the laboratory to provide a complete measurement. The radioactive iodine monitor shall have the following functions: - measure the volume activity of iodine and iodine compounds in the gaseous effluent stream and the total activity of discharged radioactive iodine; When the threshold value is reached, an alarm signal is activated. These devices measure the activity of other radionuclides present in the gaseous effluent, including natural radionuclides. Screening for other nuclides is important when measuring low levels of radioactive iodine. In chimneys or ventilation ducts, this section considers both the use of activated carbon as a sampling medium for iodine and the direct measurement of iodine. The purpose of this section is to specify specific standard requirements for iodine monitors listed in Chapter 4, including technical characteristics and general test conditions, and to give examples of possible methods. GB/T 7165.1-2005 specifies the general requirements, technical characteristics, test methods, radiation characteristics, electrical characteristics, mechanical characteristics, safety characteristics and environmental characteristics of this type of equipment. Unless otherwise stated, these requirements apply to this section.
GB/T 7165.4-2008 Referenced Document
GB 9254 Limits and methods of measurement of radio disturbance for information technology equipment*, 2008-08-06 Update
GB/T 17626.1 Electromagnetic compatibility Testing and measurement techniques Overview of immunity test
GB/T 17626.10 Electromagnetic compatibility—Testing and measurement techniques—Damped oscillatory magnetic field immunity test*, 2017-12-29 Update
GB/T 17626.11 Electromagnetic Compatibility Testing and Measurement Techniques Part 11: Voltage Dips, Short Interruptions and Voltage Variation Immunity Tests for Equipment with Input Current Less than or Equal to 16 A per Phase*, 2023-05-23 Update
GB/T 17626.12 Electromagnetic Compatibility Testing and Measurement Techniques Part 12: Ringing Wave Immunity Test*, 2023-03-17 Update
GB/T 17626.13 Electromagnetic compatibility Testing and measurement techniques Harmonics and interharmonics including mains signalling at a.c. power port, low frequency immunity test
GB/T 17626.14 Electromagnetic compatibility Testing and measurement techniques Voltage fluctuation immunity test
GB/T 17626.15 Electromagnetic compatibility.Testing and measurement techniques .Flickermeter.Functional and design specifications *, 2011-12-30 Update
GB/T 17626.16 Electromagnetic compatibility Testing and measurement techniques Test for immunity to conducted, common mode disturbances in the frequency range 0 Hz to 150 kHz
GB/T 17626.17 Electromagnetic compatibility Testing and measurement techniques Ripple on d.c.input power port immunity test
GB/T 17626.19 Electromagnetic compatibility—Testing and measurement techniques—Part 19: Test for immunity to conducted, differential mode disturbances and signalling in the frequency range 2 kHz to 150 kHz at a.c.*, 2022-12-30 Update
GB/T 17626.20 Electromagnetic compatibility.Testing and measurement techniques.Emission and immunity testing in transverse electromagnetic (TEM) waveguide*, 2014-12-22 Update
GB/T 17626.21 Electromagnetic compatibility.Testing and measurement techniques.Reverberation chamber test methods*, 2014-12-22 Update
GB/T 17626.22 Electromagnetic compatibility (EMC)—Testing and measurement techniques—Radiated emissions and immunity measurements in fully anechoic rooms(FARs)*, 2017-12-29 Update
GB/T 17626.24 Electromagnetic compatibility.Testing and measurement techniques.Test methods for protective devices for HEMP conducted disturbance*, 2012-11-05 Update
GB/T 17626.27 Electromagnetic compatibility Testing and measurement techniques Unbalance immunity test
GB/T 17626.28 Electromagnetic compatibility Testing and measurement techniques Variation of power frequency, immunity test
GB/T 17626.29 Electromagnetic compatibility Testing and measurement techniques Voltage dips, short interruptions and voltage variations on d.c.input power port immunity tests
GB/T 17626.3 Electromagnetic compatibility test and measurement technology Part 3: Radio frequency electromagnetic field radiation immunity test*, 2023-12-28 Update
GB/T 17626.30 Electromagnetic compatibility test and measurement technology Part 30: Power quality measurement methods*, 2023-12-28 Update
GB/T 17626.34 Electromagnetic compatibility.Testing and measurement techniques.Voltage dips,short interruptions and voltage variations immunity tests for equipment with mains current more than 16A per phase*, 2012-06-29 Update
GB/T 17626.4 Electromagnetic compatibility-Testing and measurement techniques-Electrical fast transient/burst immunity test*, 2018-06-07 Update
GB/T 17626.6 Electromagnetic compatibility—Testing and measurement techniques—Immunity to conducted disturbances,induced by radio-frequency fields*, 2017-12-29 Update
GB/T 17626.7 Electromagnetic compatibility—Testing and measurement techniques—General guide on harmonics and interharmonics measurements and instrumentation, for power supply systems and equipment connected thereto*, 2017-07-12 Update
GB/T 17626.8 Electromagnetic compatibility Testing and measurement techniques Power frequency magnetic field immunity test
GB/T 17626.9 Electromagnetic compatibility. Testing and measurement techniques. Pulse magnetic field immunity test *, 2011-12-30 Update
GB/T 2423.5 Environmental testing—Part 2: Test methods—Test Ea and guidance: Shock*, 2019-05-10 Update
GB/T 7165.1-2005 Equipment for continuous monitoring of radioactivity in gaseous effluents Part1:General requirements
GB/T 7165.4-2008 history
2008GB/T 7165.4-2008 Equipment for continuous monitoring of radioactivity in gaseous effluents.Part 4:Specific requirements for radioactive iodine monitors
1989GB/T 7165.4-1989 Equipment for continuously monitoring radioactivity in gaseous effluents--Part 4: Specific requirements for iodine monitors