General Administration of Quality Supervision, Inspection and Quarantine of the People‘s Republic of China
Latest
GB/T 23751.1-2009
Scope
This section applies to portable micro fuel cell power generation systems, micro fuel cell power units and fuel containers with an output DC voltage not exceeding 60V and an output power not exceeding 240W. If the output voltage of the portable fuel cell power generation system exceeds this limit, refer to IEC 62282-5-1. The products in this section are not suitable for hazardous locations defined in Chapter 3 of GB 2900.35-2008.
GB/T 23751.1-2009 Referenced Document
GB 14536.1-2008 Automatic electrical controls for household and similar use.Part 1:General requirements
GB 3836.8-2003 Electrical apparatus for explosive gas atmospheres--Part 8: Type of protection “n”
GB 4943-2001 Safety of information technology equipment
GB 8897.4 Primary batteries.Part 4:Safety of lithium batteries
GB 8897.5 Primary batteries.Part 5:Safety of batteries with aqueous electrolyte*, 2013-10-10 Update
GB/T 16842-2008 Protection of persons and equipment by enclosures.Probe for verification
GB/T 1690 Rubber,vulcanized or thermoplastic.Determination of the effect of liquids*, 2011-01-14 Update
GB/T 2900.35-2008 Electrotechnical terminology.Equipment for explosive atmospheres
GB/T 3512 Rubber, vulcanized or thermoplastic.Accelerated ageing and heat resistance tests.Air-oven method*, 2014-12-22 Update
GB/T 5169.11 Fire hazard testing for electric and electronic products.Part 11:Glowing/hot-wire based test methods.Glow-wire flammability test method for end-products(GWEPT)*, 2017-12-29 Update
GB/T 5169.16 Fire hazard testing for electric and electronic products.Part 16:Test flames.50 W horizontal and vertical flame test methods*, 2017-12-29 Update
GB/T 5169.2 Fire hazard testing for electric and electronic products—Part 2: Guidance for assessing the fire hazard—General guidelines*, 2021-10-11 Update
GB/T 7826 System Reliability Analysis Technique Failure Mode and Effects Analysis (FMEA) program*, 2012-11-05 Update
ISO 16000-3 Indoor air — Part 3: Determination of formaldehyde and other carbonyl compounds in indoor and test chamber air — Active sampling method*, 2022-09-22 Update
ISO 16000-6 Indoor air — Part 6: Determination of volatile organic compounds in indoor and test chamber air by active sampling on Tenax TA sorbent, thermal desorption and gas chromatography using MS or MS-FID*, 2021-08-20 Update
ISO 16017 Indoor, ambient and workplace air - Sampling and analysis of volatile organic compounds by sorbent tube/thermal desorption/capillary gas chromatography - Part 2: Diffusive sampling
ISO 175 Plastics - Methods of test for the determination of the effects of immersion in liquid chemicals*, 2010-10-01 Update
ISO 9772 Cellular plastics - Determination of horizontal burning characteristics of small specimens subjected to a small flame*, 2020-10-31 Update