ASTM G105-89(1997)e1
Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests

Standard No.

ASTM G105-89(1997)e1

Release Date

1989

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM G105-02

Latest

ASTM G105-20

Scope

1.1 This test method covers laboratory procedures for determining the resistance of metallic materials to scratching abrasion by means of the wet sand/rubber wheel test. It is the intent of this procedure to provide data that will reproducibly rank materials in their resistance to scratching abrasion under a specified set of conditions.

1.2 Abrasion test results are reported as volume loss in cubic millimeters. Materials of higher abrasion resistance will have a lower volume loss.

1.3 Values stated in SI units are to be regarded as the standard. Inch-pound units are provided for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM G105-89(1997)e1 history

• 2020 ASTM G105-20 Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests
• 2016 ASTM G105-16 Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests
• 2002 ASTM G105-02(2007) Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests
• 2002 ASTM G105-02 Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests
• 1989 ASTM G105-89(1997)e1 Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests