ASTM G105-20 PDF

Scope: 1.1 This test method covers laboratory procedures for determining the resistance of metallic materials to scratching abrasion by means of the wet sand/rubber wheel test. It is the intent of this procedure to provide data that will reproducibly rank materials in their resistance to scratching abrasion under a specified set of conditions. 1.2 Abrasion test results are reported as volume loss in cubic millimetres. Materials of higher abrasion resistance will have a lower volume loss. 1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM G105-20 Referenced Document

ASTM D2000 Standard Classification System for Rubber Products in Automotive Applications
ASTM D2240 Standard Test Method for Properties of Rubber &8212; Durometer Hardness*， 2024-04-21 Update
ASTM E11 Standard Specification for Wire Cloth and Sieves for Testing Purposes
ASTM E122 Standard Practice for Calculating Sample Size to Estimate, With a Specified Tolerable Error, the Average for Characteristic of a Lot or Process
ASTM E177 Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
ASTM G40 Standard Terminology Relating to Wear and Erosion
SAE J200 Classification System for Rubber Materials*， 2023-03-23 Update

2020 ASTM G105-20 Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests
2016 ASTM G105-16 Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests
2002 ASTM G105-02(2007) Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests
2002 ASTM G105-02 Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests
1989 ASTM G105-89(1997)e1 Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests