SAE AMS3346F-1996 PDF

Scope: This specification covers a silicone rubber in the form of sheet, strip, tubing, molded shapes, and extrusions. These products have been used typically for parts required to operate or seal at temperatures from -90 to +205 degrees C (-130 to +401 degrees F), compounded especially for high strength, but usage is not limited to such applications. Silicone elastomer is resistant to deterioration by weathering and aircraft piston engine oil and remains flexible over the temperature range noted. These products are not normally suitable for use in contact with gasoline or aromatic fuels and low-aniline-point petroleum-base fluids due to excessive swelling of the elastomer.

SAE AMS3346F-1996 history

2019 SAE AMS3346H-2019 Elastomer: Phenyl Methyl Vinyl Silicone (PVMQ) Low Temperature/Engine Oil Resistant High Strength/High Tear 55 to 65 Type “A” Hardness For Products in Aircraft Piston Engine Oil/Low Temperature Environments
2013 SAE AMS3346G-2013 Silicone Rubber, 1000 psi (6.89 MPa) Minimum Tensile Strength, 55-65 Durometer
2013 SAE AMS3346D-2013 Silicone Rubber 1000 psi (6.89 MPa) Minimum Tensile Strength 55 - 65 Durometer
2001 SAE AMS3346F-2001 Silicone Rubber 1000 psi (6.89 MPa) Minimum Tensile Strength 55 - 65 Durometer
1996 SAE AMS3346F-1996 Silicone Rubber 1000 psi (6.89 MPa) Minimum Tensile Strength 55 - 65 Durometer
1992 SAE AMS3346E-1992 Silicone Rubber 1000 psi (6.89 MPa) Minimum Tensile Strength 55 - 65 Durometer
1983 SAE AMS3346D-1983 SILICONE RUBBER 1000 psi (6.90 MPa) Tensile Strength 55 - 65
1976 SAE AMS3346C-1976 SILICONE RUBBER 1000 psi (6.9 MPa) Tensile Strength 55-65
1965 SAE AMS3346B-1965 SILICONE RUBBER 1000 psi 55 - 65
1962 SAE AMS3346A-1962 SILICONE RUBBER 1000 psi (55 - 65)
1956 SAE AMS3346-1956 SILICONE RUBBER 1000 psi (55 - 65)