SAE AMS3656E-1993
Polytetrafluoroethylene Extrusions, Normal Strength, As Sintered

Standard No.

SAE AMS3656E-1993

Release Date

1993

Published By

Society of Automotive Engineers (SAE)

Status

Withdraw

Replace By

SAE AMS3656E-1998

Latest

SAE AMS3656H-2011

Scope

This specification covers polytetrafluoroethylene resin in the form of extruded rods, tubes, and shapes. These products have been used typically for parts, such as insulators, bearings, seals, and back-up rings, requiring chemical inertness up to 260 degrees C (500 degrees F), but usage is not limited to such applications.

SAE AMS3656E-1993 history

• 2011 SAE AMS3656H-2011 Polytetrafluoroethylene (PTFE) Extrusions, Normal Strength, As Sintered
• 2011 SAE AMS3656D-2011 POLYTETRAFLUOROETHYLENE EXTRUSIONS Normal Strength, As Sintered, Radiographically Inspected
• 2010 SAE AMS3656G-2010 Polytetrafluoroethylene (PTFE) Extrusions, Normal Strength, As Sintered
• 2008 SAE AMS3656F-2008 Polytetrafluoroethylene (PTFE) Extrusions, Normal Strength, As Sintered
• 1998 SAE AMS3656E-1998 Polytetrafluoroethylene Extrusions Normal Strength, As Sintered
• 1993 SAE AMS3656E-1993 Polytetrafluoroethylene Extrusions, Normal Strength, As Sintered
• 1978 SAE AMS3656C-1978 Polytetrafluoroethylene Extrusions Normal Strength@ As Sintered@ Radiographically Inspected
• 1976 SAE AMS3656B-1976 POLYTETRAFLUOROETHYLENE EXTRUSIONS Normal Strength, As Sintered, Radiographically Inspected
• 1966 SAE AMS3656A-1966 POLYTETRAFLUOROETHYLENE EXTRUSIONS Normal Strength, As Sintered, Radiographically Inspected
• 1960 SAE AMS3656-1960 POLYTETRAFLUOROETHYLENE RODS AND TUBES, EXTRUDED TFE Fluorocarbon Resin As Sintered