"PURPOSE: To publish establish manufacturing tolerances. APPLICATION: Tolerances shown herein are applicable to wire@ bar@ rod@ shapes@ and tubing. Tolerances greater than standard may be necessary for some shapes; tolerances closer than standard may be possible for others. Tolerances shown herein@ however@ apply unless otherwise agreed upon by purchaser and vendor and apply to all tempers@ unless otherwise noted. The term ""excl"" is used to apply only to the higher figure of the specified range. The general temper designations ""-TX510"" and ""-TX511"" are used for brevity and denote the full temper designations -T3510@ -T4510@ -T6510@ -T8510@ -T3511@ -T4511@ -T6511@ and -T8511. There are no established tolerances for al dimensions of tubing other than round in the -TX510 and -TX511 tempers; for straightness of all forms in the -0 temper; for angularity of shapes in the ?C0 temper; for twist of bars@ shapes@ and tubing other than round in the -0 temper; and for surface roughness of tubing."
SAE AMS2205G-1965 history
1996SAE AMS2205N-1996 Tolerances Aluminum Alloy and Magnesium Alloy Extrusions
1996SAE AMS2205-1996 TOLERANCES Aluminum and Aluminum Alloy Bars, Rods and Shapes Extruded
1991SAE AMS2205M-1991 TOLERANCES Aluminum Alloy and Magnesium Alloy Extrusions
1983SAE AMS2205N-1983 Tolerances, Aluminum Alloy and Magnesium Alloy Extrusions
1983SAE AMS2205M-1983 Tolerances Aluminum Alloy and Magnesium Alloy Extrusions
1973SAE AMS2205L-1973 Tolerances Aluminum-base and Magnesium-base Alloy Extrusions
1967SAE AMS2205K-1967 Tolerances Aluminum and Magnesium Alloy Extrusions
1966SAE AMS2205J-1966 TOLERANCES Aluminum and Magnesium Alloy Extrusions
1965SAE AMS2205H-1965 TOLERANCES Aluminum and Magnesium Alloy Extrusions
1965SAE AMS2205G-1965 TOLERANCES Aluminum and Magnesium Alloy Extrusions
1964SAE AMS2205F-1964 TOLERANCES Aluminum and Magnesium Alloy Extrusions
1963SAE AMS2205E-1963 TOLERANCES Aluminum and Magnesium Alloy Extrusions
1960SAE AMS2205D-1960 TOLERANCES Aluminum and Magnesium Alloy Extrusions
1957SAE AMS2205C-1957 TOLERANCES Aluminum and Magnesium Alloy Extrusions
1951SAE AMS2205B-1951 TOLERANCES Aluminum and Aluminum Alloy Extrusions and Magnesium Alloy Extrusions
1948SAE AMS2205A-1948 TOLERANCES Aluminum and Aluminum Alloy Extrusions