SAE AMS2205M-1991
TOLERANCES Aluminum Alloy and Magnesium Alloy Extrusions

Standard No.
SAE AMS2205M-1991
Release Date
1991
Published By
Society of Automotive Engineers (SAE)
Status
Replace By
SAE AMS2205-1996
Latest
SAE AMS2205N-1996
Scope
This specification covers established manufacturing tolerances applicable to aluminum alloy and magnesium alloy extruded bar, rod, wire, shapes, and tubing ordered to inch/pound dimensions. Tolerances greater than standard may be necessary for some shapes; tolerances closer than standard may be possible for others. Tolerances shown herein, however, apply unless otherwise agreed upon by purchaser and vendor and apply to all tempers, unless otherwise noted. The term "excl" is used to apply only to the higher figure of the specified range. The general temper designations "-TX510" and "-TX511" are used for brevity and denote the full temper designations -T3510, -T4510, -T6510, -T8510, -T73510, -T76510, -T3511, -T4511, -T6511, -T8511, -T73511, and -T76511, the "X" representing one or more digits preceding the "510" or "511".

SAE AMS2205M-1991 history



Copyright ©2024 All Rights Reserved