SAE AMS2205K-1967
Tolerances Aluminum and Magnesium Alloy Extrusions

Standard No.
SAE AMS2205K-1967
Release Date
1967
Published By
SAE - SAE International
Status
 2012-12
Replace By
SAE AMS2205L-1973
Latest
SAE AMS2205N-1996
Scope
"PURPOSE: To publish established manufacturing tolerances. APPLICATION:This specification covers established manufacturing tolerances applicable to aluminum-base and magnesium-base alloy extruded bar@ rod@ wire@ shapes@ and tubing. Tolerances greater than standard may be necessary for some shapes; tolerances closer than standard may be possible for others. Tolerances shown herein@ however@ apply unless otherwise agreed upon by purchaser and vendor and apply to all tempers@ unless otherwise noted. The term ""excl"" is used to apply only to the higher figure of the specified range. The general temper designations ""TX510: and "" ?CTX511"" are used for brevity and denote the full temper designations ?CT3510@ -T4510@ -T6510@ -T8510@ -T73510@ -T76510@ -T3511@ -T4511@ -T6511@ -T8511@ -T73511@ AND ?CT76511@ the ""X"" representing one or more digits preceding the ""510"" or ""511"". There are no established tolerances for all dimensions of tubing other than round in the ?CTX510 and ?CTX511 tempers; for straightness of all forms in the -0 temper; for angularity of shapes in the -0 temper; for twist of bars@ shapes@ and tubing other than round in the -0 temper; and for surface roughness of tubing."

SAE AMS2205K-1967 history



Copyright ©2024 All Rights Reserved