ISO 20808:2016 PDF

Scope: This document specifies a procedure for and provides guidance on the determination of the coefficient of friction and the specific wear rate for monolithic ceramics. In this method, the materials are tested in pairs, in a ball-on-disc configuration, under dry, non-abrasive conditions.

ISO 20808:2016 Referenced Document

ASTM G40-13 Standard Terminology Relating to Wear and Erosion*， 2024-04-20 Update
ASTM G99-05 Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus*， 2024-04-20 Update
ISO 1101:2012 Geometrical product specifications (GPS) - Geometrical tolerancing - Tolerances of form, orientation, location and run-out
ISO 13385-1:2011 Geometrical product specifications (GPS) - Dimensional measuring equipment - Part 1: Callipers; Design and metrological characteristics
ISO 13385-2:2011 Geometrical product specifications (GPS) - Dimensional measuring equipment - Part 2: Calliper depth gauges; Design and metrological characteristics
ISO 18754:2013 Fine ceramics (advanced ceramics, advanced technical ceramics) - Determination of density and apparent porosity
ISO 3274:1996 Geometrical Product Specifications (GPS) - Surface texture: Profile method - Nominal characteristics of contact (stylus) instruments
ISO 3611:2010 Geometrical product specifications (GPS) - Dimensional measuring equipment: Micrometers for external measurements - Design and metrological characteristics
ISO 4287:1997 Geometrical Product Specification (GPS) - Surface texture: Profile method - Terms, definitions and surface texture parameters
ISO 80000-1:2009 Quantities and units - Part 1: General
ISO/IEC 17025:2005 General requirements for the competence of testing and calibration laboratories
JIS R 1613:2010 Testing method for wear resistance of fine ceramics by ball-on-disc method

2016 ISO 20808:2016 Fine ceramics (advanced ceramics, advanced technical ceramics) - Determination of friction and wear characteristics of monolithic ceramics by ball-on-disc method
2004 ISO 20808:2004 Fine ceramics (advanced ceramics, advanced technical ceramics) - Determination of friction and wear characteristics of monolithic ceramics by ball-on-disc method