ISO 11297-4:2018 PDF

Standard No.: ISO 11297-4:2018
Release Date: 2018
Published By: International Organization for Standardization (ISO)
Latest: ISO 11297-4:2018

Scope: This document, in conjunction with ISO 11297-1 and ISO 11296-4, specifies requirements and test methods for cured-in-place pipes and fittings used for the renovation of hydraulically and pneumatically pressurized underground drainage and sewerage networks with service temperatures up to 50 °C. It applies to independent (fully structural, class A) and interactive (semi structural, class B) pressure pipe liners, as defined in ISO 11295, which do not rely on adhesion to the existing pipeline. It applies to the use of various thermosetting resin systems, in combination with compatible fibrous carrier materials, reinforcement, and other process-related plastics components (see 5.1). It does not include requirements or test methods for resistance to abrasion, cyclic loading or impact, which are outside the scope of this document.

ISO 11297-4:2018 Referenced Document

ISO 10467:2004 Plastics piping systems for pressure and non-pressure drainage and sewerage - Glass-reinforced thermosetting plastics (GRP) systems based on unsaturated polyester (UP) resin
ISO 10928:2016 Plastics piping systems - Glass-reinforced thermosetting plastics (GRP) pipes and fittings - Methods for regression analysis and their use
ISO 10952:2014 Plastics piping systems - Glass-reinforced thermosetting plastics (GRP) pipes and fittings - Determination of the resistance to chemical attack for the inside of a section in a deflected condition
ISO 11295:2017 Classification and information on design and applications of plastics piping systems used for renovation and replacement
ISO 11296-4:2018 Plastics piping systems for renovation of underground non-pressure drainage and sewerage networks — Part 4: Lining with cured-in-place pipes
ISO 11297-1:2018 Plastics piping systems for renovation of underground drainage and sewerage networks under pressure - Part 1: General*， 2018-03-01 Update
ISO 11297-3:2013 Plastics piping systems for renovation of underground drainage and sewerage networks under pressure - Part 3: Lining with close-fit pipes
ISO 14125:1998 Fibre-reinforced plastic composites - Determination of flexural properties
ISO 7432:2002 Glass-reinforced thermosetting plastics (GRP) pipes and fittings - Test methods to prove the design of locked socket-and-spigot joints, including double-socket joints, with elastomeric seals
ISO 7509:2015 Plastics piping systems - Glass-reinforced thermosetting plastics (GRP) pipes - Determination of time to failure under sustained internal pressure
ISO 8521:2009 Plastics piping systems - Glass-reinforced thermosetting plastics (GRP) pipes - Test methods for the determination of the apparent initial circumferential tensile strength
ISO 8533:2003 Glass-reinforced thermosetting plastics (GRP) pipes and fittings - Test methods to prove the design of cemented or wrapped joints

ISO 11297-4:2018 history

2018 ISO 11297-4:2018 Plastics piping systems for renovation of underground drainage and sewerage networks under pressure - Part 4: Lining with cured-in-place pipes

Plastics piping systems for renovation of underground drainage and sewerage networks under pressure - Part 4: Lining with cured-in-place pipes

ISO 11297-4:2018Plastics piping systems for renovation of underground drainage and sewerage networks under pressure - Part 4: Lining with cured-in-place pipes

ISO 11297-4:2018 Referenced Document

ISO 11297-4:2018 history

ISO 11297-4:2018
Plastics piping systems for renovation of underground drainage and sewerage networks under pressure - Part 4: Lining with cured-in-place pipes