ISO 14253-1:2017 PDF

Scope: This document establishes the rules for verifying the conformity or nonconformity with a given tolerance for a characteristic of a workpiece (or a population of workpieces) or with a given maximum permissible errors for a metrological characteristic of a measuring equipment, including when the measured value falls close to the specification limits, taking measurement uncertainty into account. This document applies to specifications defined in general GPS standards (see ISO 14638), i.e. standards prepared by ISO/TC 213, including: — workpiece specifications and population specifications (usually given as an upper specification limit or a lower specification limit or both); — measuring equipment specifications (usually given as maximum permissible errors). This document only applies for characteristics and maximum permissible errors expressed as quantity values.

ISO 14253-1:2017 Referenced Document

ISO 14253-2:2011 Geometrical product specifications (GPS) - Inspection by measurement of workpieces and measuring equipment - Part 2: Guidance for the estimation of uncertainty in GPS measurement, in calibration of measuring equipment and in product verification
ISO 14638:2015 Geometrical product specifications (GPS) - Matrix model
ISO 1938-1:2015 Geometrical product specifications (GPS) - Dimensional measuring equipment - Part 1: Plain limit gauges of linear size
ISO 25378:2011 Geometrical product specifications (GPS) - Characteristics and conditions - Definitions
ISO 3534-1:2006 Statistics - Vocabulary and symbols - Part 1: General statistical terms and terms used in probability
ISO 3534-2:2006 Statistics - Vocabulary and symbols - Part 2: Applied statistics
ISO 8015:2011 Geometrical product specifications (GPS) - Fundamentals - Concepts, principles and rules
ISO 9000:2015 Quality management systems - Fundamentals and vocabulary
ISO/IEC GUIDE 98-3:2008 Uncertainty of measurement — Part 3: Guide to the expression of uncertainty in measurement (GUM:1995)
ISO/IEC GUIDE 98-4:2012 Uncertainty of measurement.Part 4: Role of measurement uncertainty in conformity assessment
ISO/IEC GUIDE 99:2007 International vocabulary of metrology - Basic and general concepts and associated terms (VIM)

2017 ISO 14253-1:2017 Geometrical product specifications (GPS) - Inspection by measurement of workpieces and measuring equipment - Part 1: Decision rules for verifying conformity or nonconformity with specifications
2013 ISO 14253-1:2013 Geometrical product specifications (GPS).Inspection by measurement of workpieces and measuring equipment.Part 1: Decision rules for proving conformity or nonconformity with specifications
1998 ISO 14253-1:1998 Geometrical Product Specifications (GPS) - Inspection by measurement of workpieces and measuring equipments - Part 1: Decision rules for proving conformance or non-conformance with specifications