ISO 1938-1:2015
Geometrical product specifications (GPS) - Dimensional measuring equipment - Part 1: Plain limit gauges of linear size

Standard No.

ISO 1938-1:2015

Release Date

2015

Published By

International Organization for Standardization (ISO)

Latest

ISO 1938-1:2015

Scope

This part of ISO 1938 specifies the most important metrological and design characteristics of plain limit gauges of linear size. This part of ISO 1938 defines the different types of plain limit gauges used to verify linear dimensional specifications associated with linear size. This part of ISO 1938 also defines the design characteristics and the metrological characteristics for these limit gauges as well as the new or wear limits state Maximum Permissible Limits (MPLs) for the new state or wear limits state for these metrological characteristics. In addition, this part of ISO 1938 describes the use of limit gauges. It covers linear sizes up to 500 mm.

ISO 1938-1:2015 Referenced Document

• ISO 1101:2012 Geometrical product specifications (GPS) - Geometrical tolerancing - Tolerances of form, orientation, location and run-out
• ISO 1302:2002 Geometrical Product Specifications (GPS) - Indication of surface texture in technical product documentation
• ISO 14253-1:2013 Geometrical product specifications (GPS).Inspection by measurement of workpieces and measuring equipment.Part 1: Decision rules for proving conformity or nonconformity with specifications
• ISO 14253-2:2011 Geometrical product specifications (GPS) - Inspection by measurement of workpieces and measuring equipment - Part 2: Guidance for the estimation of uncertainty in GPS measurement, in calibration of measuring equipment and in product verification
• ISO 14405-1:2010 Geometrical product specifications (GPS) - Dimensional tolerancing - Part 1: Linear sizes
• ISO 14638:2015 Geometrical product specifications (GPS) - Matrix model
• ISO 14978:2006 Geometrical product specifications (GPS) - General concepts and requirements for GPS measuring equipment
• ISO 17450-1:2011 Geometrical product specifications (GPS) - General concepts - Part 1: Model for geometrical specification and verification
• ISO 17450-2:2012 Geometrical product specifications (GPS) - General concepts - Part 2: Basic tenets, specifications, operators, uncertainties and ambiguities
• ISO 1:2002 Geometrical Product Specifications (GPS) - Standard reference temperature for geometrical product specification and verification
• ISO 286-1:2010 Geometrical product specifications (GPS) - ISO code system for tolerances on linear sizes - Part 1: Basis of tolerances, deviations and fits
• ISO 8015:2011 Geometrical product specifications (GPS) - Fundamentals - Concepts, principles and rules
• ISO/IEC Guide 98-3:2008 Uncertainty of measurement — Part 3: Guide to the expression of uncertainty in measurement (GUM:1995)
• ISO/IEC Guide 99:2007 International vocabulary of metrology - Basic and general concepts and associated terms (VIM)
• ISO/R 1938:1971 ISO system of limits and fits; Part II : Inspection of plain workpieces

ISO 1938-1:2015 history

• 2015 ISO 1938-1:2015 Geometrical product specifications (GPS) - Dimensional measuring equipment - Part 1: Plain limit gauges of linear size