ASTM B777-15
Standard Specification for Tungsten Base, High-Density Metal
- Standard No.
- ASTM B777-15
- Release Date
- 2015
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM B777-15(2020)
- Latest
- ASTM B777-15(2020)
- Scope
1.1 This specification covers the requirements for four classes of machinable, high-density tungsten base metal produced by consolidating metal powder mixtures, the composition of which is mainly tungsten. This material specification may be used for bare parts or for parts that may be coated with other materials for protection against corrosion and abrasion.
1.2 This specification describes physical, mechanical, and microstructural testing of a material lot based on the use of test coupons, not actual parts. Sintered properties typically vary both with part size and sampling location within a given part. Results obtained from coupon testing may therefore differ from the properties of a specific location in a larger part.
1.3 Intended Use—Parts made from this material are intended for uses such as weights or counter-balances in static or dynamic balancing, high-speed rotating inertia members, radiation shielding, hypervelocity impact, and vibration-damping applications. In selecting the appropriate alloy for a given application, it is important to note that as the tungsten content of the alloy is increased, stiffness, radiation attenuation, and density increase with an accompanying decrease in attainable ductility.
1.4 Special Applications—For particular applications, properties or requirements other than those specified in Sections 5, 6, and 7 of this specification may be important. These alloys may contain elements which make them weakly ferromagnetic. Where freedom from magnetic response is required, this should be specified in the purchase order. Class 4 is not available in a non-magnetic grade. For purposes of this specification, non-magnetic material is defined as material having a maximum magnetic permeability of 1.05 (see Test Method A342). Also for special applications involving large sections, methods for determining internal quality, such as mechanical testing of specimens excised from these larger sections or suitable nondestructive tests may be applied. If such part property data are required, an additional part-specific test program shall be specified in the purchase order.
1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
ASTM B777-15 Referenced Document
- ASTM A342/A342M Standard Test Methods for Permeability of Feebly Magnetic Materials
- ASTM B311 Test Method for Density Determination for Powder Metallurgy (P/M) Materials Containing Less Than Two Percent Porosity
- ASTM D3951 Standard Practice for Commercial Packaging
- ASTM E18 Standard Test Methods for Rockwell Hardness of Metallic Materials
- ASTM E3 Standard Practice for Preparation of Metallographic Specimens
- ASTM E407 Standard Practice for Microetching Metals and Alloys
- ASTM E8/E8M Standard Test Methods for Tension Testing of Metallic Materials
ASTM B777-15 history
- 2020 ASTM B777-15(2020) Standard Specification for Tungsten Base, High-Density Metal
- 2015 ASTM B777-15 Standard Specification for Tungsten Base, High-Density Metal
- 2007 ASTM B777-07(2013) Standard Specification for Tungsten Base, High-Density Metal
- 2007 ASTM B777-07 Standard Specification for Tungsten Base, High-Density Metal
- 1999 ASTM B777-99 Standard Specification for Tungsten Base, High-Density Metal
