ASTM F725-03(2013)
Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
- Standard No.
- ASTM F725-03(2013)
- Release Date
- 2003
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM F725-03(2018)
- Latest
- ASTM F725-03(2018)
- Scope
5.1 This practice is used for drafting impact test specification requirements, and it presupposes no special familiarity with statistical methods. It provides for specification values that will pass acceptable lots with a high degree of certainty. The impact test requirement is intended to discriminate between acceptable materials and manufacturing methods and those which are not; it is not a simulated service test.
1.1 This practice describes a procedure for setting up impact test requirements on the basis of test data obtained by Test Method D2444.
1.2 This practice is applicable to thermoplastic pipe and fittings.
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM F725-03(2013) Referenced Document
- ASTM D2444 Standard Test Method for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight)
ASTM F725-03(2013) history
- 2018 ASTM F725-03(2018) Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
- 2003 ASTM F725-03(2013) Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
- 2003 ASTM F725-03(2008)e1 Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
- 2003 ASTM F725-03e1 Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
- 2003 ASTM F725-03 Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
- 1989 ASTM F725-89(1996) Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
