ASTM F725-89(1996)
Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards

Standard No.

ASTM F725-89(1996)

Release Date

1989

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM F725-03

Latest

ASTM F725-03(2018)

Scope

1.1 This practice describes a procedure for setting up impact test requirements on the basis of test data obtained by Test Method D2444.

1.2 This practice is applicable to thermoplastic pipe and fittings.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM F725-89(1996) history

• 2018 ASTM F725-03(2018) Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
• 2003 ASTM F725-03(2013) Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
• 2003 ASTM F725-03(2008)e1 Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
• 2003 ASTM F725-03e1 Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
• 2003 ASTM F725-03 Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
• 1989 ASTM F725-89(1996) Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards