ASTM D5499-94(2013)
Standard Test Methods for Heat Resistance of Polymer Linings for Flue Gas Desulfurization Systems

Standard No.

ASTM D5499-94(2013)

Release Date

1994

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D5499-94(2021)

Latest

ASTM D5499-94(2021)

Scope

3.1 The results obtained by these test methods can be used in combination with other test methods for the selection of a lining in flue gas desulfurization (FGD) systems.

3.2 These methods are intended to evaluate effects of heat alone upon a lining system as applied to a carbon steel substrate. These methods do not produce the thermal gradient that may exist in actual applications. Actual lining performance may also be effected by concurrent physical mechanical or chemical effects.

3.3 These methods evaluate major failure modes of linings applied to square test panels.

3.4 The recommended test temperatures of 200°F (93°C) and 350°F (177°C) are based on typical maximum operating zone temperatures in flue gas desulfurizations systems. Other temperatures may be evaluated as desired.

1.1 This test method is intended to evaluate the resistance of polymer linings applied to carbon steel substrates to elevated temperatures. Two separate methods are included as follows:

1.1.1 Test Method A Continuous elevated temperature exposure, and

1.1.2 Test Method B Cycling elevated temperature exposure.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D5499-94(2013) Referenced Document

• ASTM A36/A36M Standard Specification for Carbon Structural Steel*， 1997-04-20 Update
• ASTM D1474 Standard Test Methods for Indentation Hardness of Organic Coatings*， 2008-07-01 Update
• ASTM D4417 Standard Test Methods for Field Measurement of Surface Profile of Blast Cleaned Steel
• ASTM D4541 Standard Test Method for Pull-Off Strength of Coatings Using Portable Adhesion Testers*， 1995-04-20 Update
• ASTM D660 Standard Test Method for Evaluating Degree of Checking of Exterior Paints*， 2019-10-01 Update
• ASTM D661 Standard Test Method for Evaluating Degree of Cracking of Exterior Paints*， 2019-10-01 Update
• ASTM D714 Standard Test Method for Evaluating Degree of Blistering of Paints
• ASTM D772 Standard Test Method for Evaluating Degree of Flaking (Scaling) of Exterior Paints

ASTM D5499-94(2013) history

• 2021 ASTM D5499-94(2021) Standard Test Methods for Heat Resistance of Polymer Linings for Flue Gas Desulfurization Systems
• 1994 ASTM D5499-94(2013) Standard Test Methods for Heat Resistance of Polymer Linings for Flue Gas Desulfurization Systems
• 1994 ASTM D5499-94(2007) Standard Test Methods for Heat Resistance of Polymer Linings for Flue Gas Desulfurization Systems
• 1994 ASTM D5499-94(1999) Standard Test Methods for Heat Resistance of Polymer Linings for Flue Gas Desulfurization Systems