ASTM D5499-94(2021) PDF

Scope: 1.1 These test methods are intended to evaluate the resistance of polymer linings applied to carbon steel substrates to elevated temperatures. Two separate methods are included as follows: 1.1.1 Test Method A Continuous elevated temperature exposure, and 1.1.2 Test Method B Cycling elevated temperature exposure. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D5499-94(2021) Referenced Document

ASTM A36/A36M Standard Specification for Carbon Structural Steel
ASTM D1474 Standard Test Methods for Indentation Hardness of Organic Coatings
ASTM D4417 Standard Test Methods for Field Measurement of Surface Profile of Blast Cleaned Steel
ASTM D4541 Standard Test Method for Pull-Off Strength of Coatings Using Portable Adhesion Testers
ASTM D660 Standard Test Method for Evaluating Degree of Checking of Exterior Paints
ASTM D661 Standard Test Method for Evaluating Degree of Cracking of Exterior Paints
ASTM D714 Standard Test Method for Evaluating Degree of Blistering of Paints
ASTM D772 Standard Test Method for Evaluating Degree of Flaking (Scaling) of Exterior Paints

2021 ASTM D5499-94(2021) Standard Test Methods for Heat Resistance of Polymer Linings for Flue Gas Desulfurization Systems
1994 ASTM D5499-94(2013) Standard Test Methods for Heat Resistance of Polymer Linings for Flue Gas Desulfurization Systems
1994 ASTM D5499-94(2007) Standard Test Methods for Heat Resistance of Polymer Linings for Flue Gas Desulfurization Systems
1994 ASTM D5499-94(1999) Standard Test Methods for Heat Resistance of Polymer Linings for Flue Gas Desulfurization Systems