SAE AMS3660E-2011 PDF

Scope: This specification covers virgin, unfilled, polytetrafluoroethylene (PTFE) in the form of molded rods, tubes, and shapes. This specification does not apply to product over 12 inches (305 mm) in dimension parallel to the direction of applied molding pressure, rods under 0.750 inch (19.05 mm) in diameter, and tubes having wall thickness under 0.500 inch (12.70 mm). These moldings have been used typically for parts such as, bushings and insulators, requiring chemical inertness and good mechanical and electrical properties up to 500 °C (260 °F), but usage is not limited to such applications. For applications such as bearins, seals, and back-up rings that do not require dielectric properties it is recommended to use AMS 3678/1 Grade A.

SAE AMS3660E-2011 Referenced Document

ASTM D149-09 Standard Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies*， 2024-04-19 Update
ASTM D4894-07 Standard Specification for Polytetrafluoroethylene (PTFE) Granular Molding and Ram Extrusion Materials*， 2024-04-19 Update
ASTM D792-08 Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by Displacement*， 2024-04-19 Update

2011 SAE AMS3660E-2011 Polytetrafluoroethylene (PTFE) Moldings, General Purpose Grade, As Sintered
2011 SAE AMS3660B-2011 POLYTETRAFLUOROETHYLENE MOLDINGS General Purpose Grade, As Sintered
2010 SAE AMS3660D-2010 Polytetrafluoroethylene (PTFE) Moldings, General Purpose Grade, As Sintered
2003 SAE AMS3660C-2003 Polytetrafluoroethylene (PTFE) Moldings General Purpose Grade, As Sintered
1994 SAE AMS3660C-1994 Polytetrafluoroethylene (PTFE) Moldings, General Purpose Grade, As Sintered
1976 SAE AMS3660A-1976 POLYTETRAFLUOROETHYLENE MOLDINGS General Purpose Grade, As Sintered
1966 SAE AMS3660-1966 POLYTETRAFLUOROETHYLENE MOLDINGS General Purpose Grade, As Sintered