SAE AMS3660C-1994
Polytetrafluoroethylene (PTFE) Moldings, General Purpose Grade, As Sintered

Standard No.

SAE AMS3660C-1994

Release Date

1994

Published By

Society of Automotive Engineers (SAE)

Status

Withdraw

Replace By

SAE AMS3660C-2003

Latest

SAE AMS3660E-2011

Scope

This specification covers virgin, unfilled, polytetrafluoroethylene (PTFE) in the form of molded rods, tubes, and shapes. This specification does not apply to product over 12 inches (305 mm) in dimension parallel to the direction of applied molding pressure, rods under 0.750 inch (19.05 mm) in diameter, and tubes having wall thickness under 0.500 inch (12.70 mm). These moldings have been used typically for parts, such as seals, bearings, insulators, and back-up rings, requiring chemical inertness and good mechanical and electrical properties up to 260 degrees C (500 degrees F), but usage is not limited to such applications.

SAE AMS3660C-1994 history

• 2011 SAE AMS3660E-2011 Polytetrafluoroethylene (PTFE) Moldings, General Purpose Grade, As Sintered
• 2011 SAE AMS3660B-2011 POLYTETRAFLUOROETHYLENE MOLDINGS General Purpose Grade, As Sintered
• 2010 SAE AMS3660D-2010 Polytetrafluoroethylene (PTFE) Moldings, General Purpose Grade, As Sintered
• 2003 SAE AMS3660C-2003 Polytetrafluoroethylene (PTFE) Moldings General Purpose Grade, As Sintered
• 1994 SAE AMS3660C-1994 Polytetrafluoroethylene (PTFE) Moldings, General Purpose Grade, As Sintered
• 1976 SAE AMS3660A-1976 POLYTETRAFLUOROETHYLENE MOLDINGS General Purpose Grade, As Sintered
• 1966 SAE AMS3660-1966 POLYTETRAFLUOROETHYLENE MOLDINGS General Purpose Grade, As Sintered