ASTM D6356/D6356M-98(2011)e1
Standard Test Method for Hydrogen Gas Generation of Aluminum Emulsified Asphalt Used as a Protective Coating for Roofing

Standard No.

ASTM D6356/D6356M-98(2011)e1

Release Date

1998

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D6356/D6356M-98(2018)

Latest

ASTM D6356/D6356M-98(2018)

Scope

This procedure measures the amount of hydrogen gas generation potential of aluminized emulsion roof coating. There is the possibility of water reacting with aluminum pigment to generate hydrogen gas. This situation is to be avoided, so this test was designed to evaluate coating formulations and assess the propensity to gassing.

1.1 This test method covers a hydrogen gas and stability test for aluminum emulsified asphalt coatings.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D6356/D6356M-98(2011)e1 Referenced Document

• ASTM D1079 Standard Terminology Relating to Roofing and Waterproofing*， 2020-05-01 Update
• ASTM D2939 Standard Test Methods for Emulsified Bitumens Used as Protective Coatings
• ASTM E1 Standard Specification for ASTM Thermometers

ASTM D6356/D6356M-98(2011)e1 history

• 2018 ASTM D6356/D6356M-98(2018) Standard Test Method for Hydrogen Gas Generation of Aluminum Emulsified Asphalt Used as a Protective Coating for Roofing
• 1998 ASTM D6356/D6356M-98(2011)e1 Standard Test Method for Hydrogen Gas Generation of Aluminum Emulsified Asphalt Used as a Protective Coating for Roofing
• 1998 ASTM D6356-98(2004) Standard Test Method for Hydrogen Gas Generation of Aluminum Emulsified Asphalt Used as a Protective Coating for Roofing
• 1998 ASTM D6356-98 Standard Test Method for Hydrogen Gas Generation of Aluminum Emulsified Asphalt Used as a Protective Coating for Roofing