ASTM D6356/D6356M-98(2018) PDF

Scope: 1.1 This test method covers a hydrogen gas and stability test for aluminum emulsified asphalt coatings. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D6356/D6356M-98(2018) Referenced Document

ASTM D1079 Standard Terminology Relating to Roofing and Waterproofing*， 2020-05-01 Update
ASTM D2939 Standard Test Methods for Emulsified Bitumens Used as Protective Coatings
ASTM E1 Standard Specification for ASTM Thermometers

2018 ASTM D6356/D6356M-98(2018) Standard Test Method for Hydrogen Gas Generation of Aluminum Emulsified Asphalt Used as a Protective Coating for Roofing
1998 ASTM D6356/D6356M-98(2011)e1 Standard Test Method for Hydrogen Gas Generation of Aluminum Emulsified Asphalt Used as a Protective Coating for Roofing
1998 ASTM D6356-98(2004) Standard Test Method for Hydrogen Gas Generation of Aluminum Emulsified Asphalt Used as a Protective Coating for Roofing
1998 ASTM D6356-98 Standard Test Method for Hydrogen Gas Generation of Aluminum Emulsified Asphalt Used as a Protective Coating for Roofing