ASTM D6/D6M-95(2011)e1
Standard Test Method for Loss on Heating of Oil and Asphaltic Compounds

Standard No.

ASTM D6/D6M-95(2011)e1

Release Date

1995

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM D6/D6M-95(2018)

Latest

ASTM D6/D6M-95(2018)

Scope

This test method is useful in characterizing certain petroleum products by the determination of their loss of mass upon heating under standardized conditions.

1.1 This test method covers the determination of the loss in mass (exclusive of water) of oil and asphaltic compounds when heated as hereinafter prescribed.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability and regulatory limitations prior to use.

ASTM D6/D6M-95(2011)e1 Referenced Document

• ASTM D5 Standard Test Method for Penetration of Bituminous Materials*， 1997-04-19 Update
• ASTM E1 Standard Specification for ASTM Thermometers*， 1998-04-19 Update
• ASTM E145 Standard Specification for Gravity-Convection And Forced-Ventilation Ovens

ASTM D6/D6M-95(2011)e1 history

• 2018 ASTM D6/D6M-95(2018) Standard Test Method for Loss on Heating of Oil and Asphaltic Compounds
• 1995 ASTM D6/D6M-95(2011)e1 Standard Test Method for Loss on Heating of Oil and Asphaltic Compounds
• 2006 ASTM D6-95(2006) Standard Test Method for Loss on Heating of Oil and Asphaltic Compounds
• 1995 ASTM D6-95(2000)e1 Standard Test Method for Loss on Heating of Oil and Asphaltic Compounds