ASTM D6/D6M-95(2018) PDF

Scope: 1.1 This test method covers the determination of the loss in mass (exclusive of water) of oil and asphaltic compounds when heated as hereinafter prescribed. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability and regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D6/D6M-95(2018) Referenced Document

ASTM D5/D5M Standard Test Method for Penetration of Bituminous Materials*， 2020-05-01 Update
ASTM E1 Standard Specification for ASTM Thermometers
ASTM E145 Standard Specification for Gravity-Convection And Forced-Ventilation Ovens

2018 ASTM D6/D6M-95(2018) Standard Test Method for Loss on Heating of Oil and Asphaltic Compounds
1995 ASTM D6/D6M-95(2011)e1 Standard Test Method for Loss on Heating of Oil and Asphaltic Compounds
2006 ASTM D6-95(2006) Standard Test Method for Loss on Heating of Oil and Asphaltic Compounds
1995 ASTM D6-95(2000)e1 Standard Test Method for Loss on Heating of Oil and Asphaltic Compounds