GB 22380.2-2010 Explosion protected safety technique of the petrol filling station.Part 2:Safety requirements for construction and performance of safe breaks for use on dispensers (English Version)
This part specifies the safety requirements for the structure and performance of safety breakaway valves for fuel tankers installed at gas stations to add liquid fuel to vehicles, ships, light aircraft or mobile tank containers with a flow rate not greater than 200L/min. This part applies to safety break valves for fuel tankers installed at gas stations to add liquid fuel to vehicles, ships, light aircraft or mobile tank containers with a flow rate not greater than 200L/min. This part pays special attention to the electrical, mechanical and hydraulic performance of the safety break valve, and the electrical equipment installed inside or outside the safety break valve. This part mainly deals with the danger of ignition of liquid fuel or its vapor during refueling. This section also deals with electrical and non-electrical hazards.
GB 22380.2-2010 Referenced Document
EN 13483:2005 Rubber and plastic hoses and hose assemblies with internal vapour recovery for measured fuel dispensing systems - Specification
GB 10543 Rubber hoses and hose assemblies for aircraft ground fuelling and defuelling.Specification*, 2014-12-22 Update
GB 17930 Gasoline for motor vehicles*, 2016-12-23 Update
GB 18351 Ethanol gasoline for motor vehicles (E10)*, 2017-09-07 Update
GB 22380.1-2008 Explosion peotected safety technique of the petrol filling station.Part 1:Explosion protected safety technique requirements for fuel filling dispenser
GB 25285.1-2010 Explosive atmospheres.Explosion prevention and protection.Part 1:Basic concepts and methodology
GB 25286.1-2010 Non-electrical equipment for explosive atmospheres.Part 1:Basic method and requirements
GB/T 193 General purpose metric screw threads--General plan
GB/T 7307 Pipe threads with 55 degree thread angle where pressure-tight joints are not made on the threads
GB/T 9145 General purpose metric screw threads--Limits of sizes for the screw threads of medium quality and preferable plan
GB/T 9572-2001 Rubber and plastics hoses and hose assemblies--Determination of electrical resistance
ISO 11925-3 Reaction to fire tests - Ignitability of building products subjected to direct impingement of flame - Part 3: Multi-source test; Technical Corrigendum 1
GB 22380.2-2010 history
2019GB/T 22380.2-2019 Explosion protected safety technique of the petrol filling station—Part 2:Safety requirements for construction and performance of safe breaks for use on dispensers
2010GB 22380.2-2010 Explosion protected safety technique of the petrol filling station.Part 2:Safety requirements for construction and performance of safe breaks for use on dispensers
GB 22380.2-2010 Explosion protected safety technique of the petrol filling station.Part 2:Safety requirements for construction and performance of safe breaks for use on dispensers was changed to GB/T 22380.2-2019 Explosion protected safety technique of the petrol filling station—Part 2:Safety requirements for construction and performance of safe breaks for use on dispensers.