ASTM D7508/D7508M-10
Standard Specification for Polyolefin Chopped Strands for Use in Concrete

Standard No.
ASTM D7508/D7508M-10
Release Date
2010
Published By
American Society for Testing and Materials (ASTM)
Status
Replace By
ASTM D7508/D7508M-10(2015)
Latest
ASTM D7508/D7508M-20
Scope

1.1 This specification covers polyolefin chopped strands (fibers) for use in concrete.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 The following safety hazards caveat pertains only to the test methods described in this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D7508/D7508M-10 Referenced Document

  • ASTM C1116/C1116M Standard Specification for Fiber-Reinforced Concrete
  • ASTM D123 Standard Terminology Relating to Textiles
  • ASTM D1577 Standard Test Methods for Linear Density of Textile Fibers
  • ASTM D1776 Standard Practice for Conditioning and Testing Textiles
  • ASTM D1907 Standard Test Method for Linear Density of Yarn (Yarn Number) by the Skein Method
  • ASTM D2256 Standard Test Method for Tensile Properties of Yarns by the Single-Strand Method
  • ASTM D2257 Standard Test Method for Extractable Matter in Textiles
  • ASTM D2258 Standard Practice for Sampling Yarn for Testing
  • ASTM D3218 Standard Specification for Polyolefin Monofilaments

ASTM D7508/D7508M-10 history

Standard Specification for Polyolefin Chopped Strands for Use in Concrete


Copyright ©2024 All Rights Reserved