This European Standard specifies requirements for continuously electrolytic zinc coated cold rolled flat products of low carbon steels suitable for cold forming according to Table 1 in rolled widths >= 600 mm and thicknesses from 0;35 mm up to and including 3 mm; delivered as strip (in coil form); sheet; slit strip or cut lengths obtained from slit strip or sheet. NOTE 1This European Standard can also be applied to continuously electrolytic zinc coated flat products of: a) steels according to EN 10139 (cold rolled strip in rolled widths < 600 mm); b) steels normally characterized by minimum yield strength or minimum tensile strength values in addition to formability parameters; e. g. 1) steels with high yield strength and improved formability according to EN 10268 (cold rolled flat products); 2) multiphase steels (cold rolled or hot rolled) according to prEN 10338; 3) steels for construction according to national or regional standards (see e. g. DIN 1623). NOTE 2 By agreement at the time of enquiry and orderThis European Standard can be applied to continuously electrolytic zinc coated hot-rolled steel flat products (e. g. according to EN 10025-1 and-2; EN 10111; EN 10149-1 to EN 10149-3; etc.). NOTE 3 As the mass of the zinc coating applied is relatively small; the material is not intended to withstand outside exposure without further chemical treatment and painting.
EN 10152:2009 Referenced Document
EN 10002-1:2001 Metallic Materials - Tensile Testing - Part 1: Method of Test at Ambient Temperature
EN 10020:2000 Definition and classification of grades of steel
EN 10021:2006 General technical delivery conditions for steel products*， 2024-04-19 Update
EN 10027-1 Designation Systems for Steels - Part 1: Steel Names
EN 10027-2 Designation systems for steels - Part 2: Numerical system*， 2015-04-01 Update
EN 10051 Continuously hot-rolled strip and plate/sheet cut from wide strip of non-alloy and alloy steels - Tolerances on dimensions and shape*， 2024-04-19 Update
EN 10131 Cold rolled uncoated and zinc or zinc-nickel electrolytically coated low carbon and high yield strength steel flat products for cold forming - Tolerances on dimensions and shape
EN 10204:2004 Metallic products - Types of inspection documents*， 2024-04-19 Update
EN ISO 7438 Metallic materials - Bend test (ISO 7438:2020)*， 2020-10-21 Update
ISO 10113 Metallic materials — Sheet and strip — Determination of plastic strain ratio*， 2020-01-27 Update