- Standard No.
- EN 10051:2010
- Release Date
- 2010
- Published By
- European Committee for Standardization (CEN)
- Latest
-
EN 10051:2010
- Replace
-
BS EN 10051:1991+A1:1997
- Scope
- This European Standard specifies tolerances on dimensions and shape for continuously hot-rolled uncoated plate/sheet and strip with a maximum width of 2200 mm of non-alloy and alloy steels in accordance with Table 1 (see also Annex A).This European Standard also applies to hot-rolled strip for cold rolling.This European Standard does not apply to stainless steels and not to hot-rolled strip rolled in widths w < 600 mm (see EN 10048).
EN 10051:2010 Referenced Document
- EN 10020 Definition and classification of grades of steel
- EN 10048 Hot rolled narrow steel strip - Tolerances on dimensions and shape
- EN 10079 Definition of steel products
EN 10051:2010 history
- 2010 EN 10051:2010 Continuously hot-rolled strip and plate/sheet cut from wide strip of non-alloy and alloy steels - Tolerances on dimensions and shape
- 1991 EN 10051:1991 Continuously Hot-Rolled Uncoated Plate, Sheet and Strip of Non-Alloy and Alloy Steels - Tolerances on Dimensions and Shape Incorporates Amendment 1; September 1997
EN 10051:2010 Continuously hot-rolled strip and plate/sheet cut from wide strip of non-alloy and alloy steels - Tolerances on dimensions and shape has been changed from BS EN 10051:1991+A1:1997 Continuously hot-rolled uncoated plate, sheet and strip of non-alloy and alloy steels - Tolerances on dimensions and shape.