GB/T 17040-2008 (English Version) PDF

Standard No.: GB/T 17040-2008
Language: Chinese, Available in English version
Release Date: 2008
Published By: General Administration of Quality Supervision, Inspection and Quarantine of the People‘s Republic of China
Status: Be replaced 2019-10
Replace By: GB/T 17040-2019
Latest: GB/T 17040-2019
Replace: GB/T 17040-1997

Scope: This standard specifies the test method for the determination of sulfur content in petroleum and petroleum products by energy dispersive X-ray fluorescence spectrometry. This standard applies to the determination of sulfur content in hydrocarbons including diesel oil, naphtha, kerosene, residual oil, lubricating base oil, hydraulic oil, jet fuel, crude oil, motor gasoline, and other distillates. In addition, for the sulfur content of other products, such as M85 and M100, this standard can also be used for analysis. The measured sulfur content range (mass fraction) from 0.0150% to 5.00%. This standard uses the International System of Units (SI) units. The mass fraction of sulfur content is expressed in %. This standard addresses certain hazardous materials, practices and equipment. However, it does not advise on all security issues related to this. Therefore, it is necessary for users to establish appropriate safety precautions and determine appropriate management systems before using this standard. See Chapter 7 for some special precautionary instructions.

GB/T 17040-2008 Referenced Document

GB/T 4756 Method for manual sampling of petroleum liquids*， 2015-12-31 Update
SH/T 0253 Determination of total sulfur content in light petroleum products (electrical method)

2019 GB/T 17040-2019 Determination of sulfur in petroleum and petroleum products—Energy dispersive X-ray fluorescence spectrometry
2008 GB/T 17040-2008 Standard test method for sulfur in petrolem and petroleum products by energy dispersive X-ray fluorescence spectrometry
1997 GB/T 17040-1997 Petroleum products--Determination of sulfur--Energy-dispersive X-ray fluorescence spectroscopy