ASTM D6334-98
Standard Test Method for Sulfur in Gasoline by Wavelength Dispersive X-Ray Fluorescence

Standard No.
ASTM D6334-98
Release Date
1998
Published By
American Society for Testing and Materials (ASTM)
Status
Replace By
ASTM D6334-98(2003)e1
Latest
ASTM D6334-12(2017)e1
Scope

1.1 This test method covers the quantitative determination of total sulfur in gasoline and gasoline-oxygenate blends. The Pooled Limit of Quantitation (PLOQ) was determined to be 15 mg/kg. Therefore, the practical range for this test method is from 15 to 940 mg/kg.

Note 1-This concentration range is based on that used in the interlaboratory round robin as reported in Research Report , which shows that the range of sulfur in the round robin samples was from 1.5 to 940 mg/kg; however, below 15 mg/kg, the reproducibility approaches 100% of the concentration.

1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard information, see Note 2.

1.3 The values stated in SI units are to be regarded as the standard. The preferred units are mg/kg sulfur.

ASTM D6334-98 history

  • 2017 ASTM D6334-12(2017)e1 Standard Test Method for Sulfur in Gasoline by Wavelength Dispersive X-Ray Fluorescence
  • 2012 ASTM D6334-12(2017) Standard Test Method for Sulfur in Gasoline by Wavelength Dispersive X-Ray Fluorescence
  • 2012 ASTM D6334-12 Standard Test Method for Sulfur in Gasoline by Wavelength Dispersive X-Ray Fluorescence
  • 2007 ASTM D6334-07 Standard Test Method for Sulfur in Gasoline by Wavelength Dispersive X-Ray Fluorescence
  • 1998 ASTM D6334-98(2003)e1 Standard Test Method for Sulfur in Gasoline by Wavelength Dispersive X-Ray Fluorescence
  • 1998 ASTM D6334-98 Standard Test Method for Sulfur in Gasoline by Wavelength Dispersive X-Ray Fluorescence



Copyright ©2024 All Rights Reserved