ASTM D6334-12(2017)e1 PDF

Scope: 1.1 This test method covers the quantitative determination of total sulfur in gasoline and gasoline-oxygenate blends. The Pooled Limit of Quantitation (PLOQ) was determined to be 15 mg ⁄kg. Therefore, the practical range for this test method is from 15 mg ⁄kg to 940 mg ⁄kg. NOTE 1—This concentration range is based on that used in the interlaboratory round robin, which shows that the range of sulfur in the round robin samples was from 1.5 mg ⁄kg to 940 mg ⁄kg; however, below 15 mg ⁄kg, the reproducibility approaches 100 % of the concentration. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.3 The values stated in SI units are to be regarded as the standard. The preferred units are mg/kg sulfur. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D6334-12(2017)e1 Referenced Document

ASTM D2622 Standard Test Method for Sulfur in Petroleum Products by Wavelength Dispersive X-ray Fluorescence Spectrometry
ASTM D3210 Standard Test Method for Comparing Colors of Films from Water-Emulsion Floor Polishes*， 2023-09-13 Update
ASTM D4045 Standard Test Method for Sulfur in Petroleum Products by Hydrogenolysis and Rateometric Colorimetry
ASTM D4057 Standard Practice for Manual Sampling of Petroleum and Petroleum Products
ASTM D4177 Standard Practice for Automatic Sampling of Petroleum and Petroleum Products
ASTM D4294 Standard Test Method for Sulfur in Petroleum Products by Energy-Dispersive X-Ray Fluorescence Spectroscopy
ASTM D5453 Standard Test Method for Determination of Total Sulfur in Light Hydrocarbons, Spark Ignition Engine Fuel, Diesel Engine Fuel, and Engine Oil by Ultraviolet Fluorescence*， 2019-07-01 Update
ASTM D5842 Standard Practice for Sampling and Handling of Fuels for Volatility Measurement
ASTM D5854 Standard Practice for Mixing and Handling of Liquid Samples of Petroleum and Petroleum Products
ASTM D6299 Standard Practice for Applying Statistical Quality Assurance and Control Charting Techniques to Evaluate Analytical Measurement System Performance*， 2023-07-01 Update
ASTM D6792 Standard Practice for Quality Management Systems in Petroleum Products, Liquid Fuels, and Lubricants Testing Laboratories*， 2023-11-01 Update

2017 ASTM D6334-12(2017)e1 Standard Test Method for Sulfur in Gasoline by Wavelength Dispersive X-Ray Fluorescence
2012 ASTM D6334-12(2017) Standard Test Method for Sulfur in Gasoline by Wavelength Dispersive X-Ray Fluorescence
2012 ASTM D6334-12 Standard Test Method for Sulfur in Gasoline by Wavelength Dispersive X-Ray Fluorescence
2007 ASTM D6334-07 Standard Test Method for Sulfur in Gasoline by Wavelength Dispersive X-Ray Fluorescence
1998 ASTM D6334-98(2003)e1 Standard Test Method for Sulfur in Gasoline by Wavelength Dispersive X-Ray Fluorescence
1998 ASTM D6334-98 Standard Test Method for Sulfur in Gasoline by Wavelength Dispersive X-Ray Fluorescence