ASTM D2911-94(2005)
Standard Specification for Dimensions and Tolerances for Plastic Bottles
- Standard No.
- ASTM D2911-94(2005)
- Release Date
- 1994
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM D2911-10
- Latest
- ASTM D2911/D2911M-16(2023)
- Scope
1.1 This specification covers the thread configuration and dimensions for finishes for plastic bottles with screw-type closures, having a maximum capacity of 18.9 L (5 gal) and a maximum bottle dimension of 305 mm (12 in.). Included are tolerances for bottle capacity and body dimensions.
1.2 The values stated in SI units are to be regarded as the standard.
1.3 The following precautionary caveat pertains only to the test methods portion, Section of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Note 18212;There is no similar or equivalent ISO standard.
ASTM D2911-94(2005) Referenced Document
- ASTM D1898
- ASTM D618 Standard Practice for Conditioning Plastics for Testing*， 2021-07-15 Update
ASTM D2911-94(2005) history
- 2023 ASTM D2911/D2911M-16(2023) Standard Specification for Dimensions and Tolerances for Plastic Bottles
- 2016 ASTM D2911/D2911M-16 Standard Specification for Dimensions and Tolerances for Plastic Bottles
- 2010 ASTM D2911-10 Standard Specification for Dimensions and Tolerances for Plastic Bottles
- 1994 ASTM D2911-94(2005) Standard Specification for Dimensions and Tolerances for Plastic Bottles
- 1994 ASTM D2911-94(2001) Standard Specification for Dimensions and Tolerances for Plastic Bottles
- 2001 ASTM D2911-94 Standard Specification for Dimensions and Tolerances for Plastic Bottles
