ASTM D618-21
Standard Practice for Conditioning Plastics for Testing

Standard No.

ASTM D618-21

Release Date

2021

Published By

American Society for Testing and Materials (ASTM)

Latest

ASTM D618-21

Scope

1.1 In general, the physical and electrical properties of plastics are influenced by temperature and relative humidity in a manner that materially affects test results. In order to make reliable comparisons between different materials and between different laboratories, it is necessary to standardize the humidity conditions, as well as the temperature, to which specimens of these materials are subjected prior to and during testing. This practice defines procedures for conditioning plastics (although not necessarily to equilibrium) prior to testing, and the conditions under which they shall be tested. 1.2 For some materials, it is possible that a material specification exists that requires the use of this practice, but with some procedural modifications. The material specification takes precedence over this practice. Refer to the material specification before using this practice. Table 1 in Classification D4000 lists the ASTM material specifications that currently exist. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. NOTE 1—This standard and ISO 291 address the same subject matter, but differ in technical content. ISO 291 describes only two temperature and humidity conditions for conditioning or testing, or both. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D618-21 Referenced Document

• ASTM D4000 Standard Classification System for Specifying Plastic Materials*， 2023-03-15 Update
• ASTM D5032 Standard Practice for Maintaining Constant Relative Humidity by Means of Aqueous Glycerin Solutions
• ASTM D709 Standard Specification for Laminated Thermosetting Materials*， 2024-04-22 Update
• ASTM D756 Standard Specification for Aviation Turbine Fuel Containing Synthesized Hydrocarbons
• ASTM D883 Standard Terminology Relating to Plastics*， 2024-02-01 Update
• ASTM E104 Standard Practice for Maintaining Constant Relative Humidity by Means of Aqueous Solutions
• ISO 291 Plastics - Standard atmospheres for conditioning and testing

ASTM D618-21 history

• 2021 ASTM D618-21 Standard Practice for Conditioning Plastics for Testing
• 2013 ASTM D618-13 Standard Practice for Conditioning Plastics for Testing
• 2008 ASTM D618-08 Standard Practice for Conditioning Plastics for Testing
• 2005 ASTM D618-05 Standard Practice for Conditioning Plastics for Testing
• 2000 ASTM D618-00 Standard Practice for Conditioning Plastics for Testing