ASTM D2104-03
Standard Specification for Polyethylene (PE) Plastic Pipe, Schedule 40

Standard No.

ASTM D2104-03

Release Date

2003

Published By

American Society for Testing and Materials (ASTM)

Status

Withdraw 2010-08

Latest

ASTM D2104-03

Scope

1.1 This specification covers polyethylene (PE) pipe made in Schedule 40 size for use with insert fittings (inside diameter controlled) and pressure-rated for water (see Appendix). Included are criteria for classifying PE plastic pipe materials and PE plastic pipe, a system of nomenclature for PE plastic pipe, and requirements and test methods for materials, workmanship, dimensions, sustained pressure, burst pressure, and environmental stress cracking. Requirements for marking are also given.

1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 The following safety hazards caveat pertains only to the test methods portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM D2104-03 Referenced Document

• ASTM D1238 Standard Test Method for Flow Rates of Thermoplastics by Extrusion Plastometer
• ASTM D1248 Standard Specification for Polyethylene Plastics Molding and Extrusion Materials
• ASTM D1505 Standard Test Method for Density of Plastics by the Density-Gradient Technique
• ASTM D1598 Standard Test Method for Time-to-Failure of Plastic Pipe Under Constant Internal Pressure
• ASTM D1599 Standard Test Method for Resistance to Short-Time Hydraulic Failure Pressure of Plastic Pipe, Tubing, and Fittings
• ASTM D1600 Standard Terminology for Abbreviated Terms Relating to Plastics
• ASTM D1603 Standard Test Method for Carbon Black In Olefin Plastics
• ASTM D2122 Standard Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings
• ASTM D2837 Standard Test Method for Obtaining Hydrostatic Design Basis for Thermoplastic Pipe Materials
• ASTM D3350 Standard Specification for Polyethylene Plastics Pipe and Fittings Materials*， 2024-04-19 Update
• ASTM D618 Standard Practice for Conditioning Plastics for Testing
• ASTM F412 Standard Terminology Relating to Plastic Piping Systems

ASTM D2104-03 history

• 2003 ASTM D2104-03 Standard Specification for Polyethylene (PE) Plastic Pipe, Schedule 40
• 2001 ASTM D2104-01 Standard Specification for Polyethylene (PE) Plastic Pipe, Schedule 40
• 1999 ASTM D2104-99e1 Standard Specification for Polyethylene (PE) Plastic Pipe, Schedule 40