ASTM C195-00
Standard Specification for Mineral Fiber Thermal Insulating Cement
- Standard No.
- ASTM C195-00
- Release Date
- 2000
- Published By
- American Society for Testing and Materials (ASTM)
- Status
- Replace By
- ASTM C195-07
- Latest
- ASTM C195-07(2019)
- Scope
1.1 This specification covers mineral fiber thermal insulating materials in the form of dry cement, which, when mixed with a suitable proportion of water, applied as a plastic mass, and dried in place, affords resistance to heat transmission on surfaces operating at temperatures between 250 and 1900oF (about 121and 1038oC).
1.2 The values stated in inch-pound units are to be regarded as the standard. The SI equivalents of inch-pound units are given in parentheses and may be approximate.
1.3 The following safety hazards caveat pertains only to the test methods section of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM C195-00 Referenced Document
- ASTM C1045 Standard Practice for Calculating Thermal Transmission Properties Under Steady-State Conditions
- ASTM C1058 Standard Practice for Selecting Temperatures for Evaluating and Reporting Thermal Properties of Thermal Insulation
- ASTM C1114 Standard Test Method for Steady-State Thermal Transmission Properties by Means of the Thin-Heater Apparatus
- ASTM C163 Standard Practice for Mixing Thermal Insulating Cement Samples
- ASTM C166 Standard Test Method for Covering Capacity and Volume Change Upon Drying of Thermal Insulating Cement
- ASTM C168 Standard Terminology Relating to Thermal Insulation
- ASTM C177 Standard Test Method for Steady-State Heat Flux Measurements and Thermal Transmission Properties by Means of the Guarded-Hot-Plate Apparatus
- ASTM C353
- ASTM C354 Standard Test Method for Compressive Strength of Thermal Insulating or Finishing Cement (Withdrawn 2002)
- ASTM C356 Standard Test Method for Linear Shrinkage of Preformed High-Temperature Thermal Insulation Subjected to Soaking Heat
- ASTM C390 Standard Criteria for Sampling and Acceptance of Preformed Thermal Insulation Lots
- ASTM C405 Standard Practice for Estimating Consistency of Wet-Mixed Thermal Insulating Cement (Withdrawn 2006)
- ASTM C411 Standard Test Method for Hot-Surface Performance of High-Temperature Thermal Insulation
- ASTM C518 Standard Test Method for Steady-State Thermal Transmission Properties by Means of the Heat Flow Meter Apparatus
- ASTM E136 Standard Test Method for Behavior of Materials in a Vertical Tube Furnace at 750oC
ASTM C195-00 history
- 2019 ASTM C195-07(2019) Standard Specification for Mineral Fiber Thermal Insulating Cement
- 2007 ASTM C195-07(2013) Standard Specification for Mineral Fiber Thermal Insulating Cement
- 2007 ASTM C195-07 Standard Specification for Mineral Fiber Thermal Insulating Cement
- 2000 ASTM C195-00 Standard Specification for Mineral Fiber Thermal Insulating Cement
