ASTM C195-07(2019) PDF

Scope: 1.1 This specification covers mineral fiber thermal insulating materials in the form of dry cement, which, when mixed with a suitable proportion of water, applied as a plastic mass, and dried in place, affords resistance to heat transmission on surfaces operating at temperatures between 250 and 1900°F (about 121 and 1038°C). 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 The following safety hazards caveat pertains only to the test methods section of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM C195-07(2019) Referenced Document

ASTM C1045 Standard Practice for Calculating Thermal Transmission Properties Under Steady-State Conditions
ASTM C1058 Standard Practice for Selecting Temperatures for Evaluating and Reporting Thermal Properties of Thermal Insulation
ASTM C1114 Standard Test Method for Steady-State Thermal Transmission Properties by Means of the Thin-Heater Apparatus
ASTM C136 Standard Test Method for Sieve Analysis of Fine and Coarse Aggregates
ASTM C163 Standard Practice for Mixing Thermal Insulating Cement Samples
ASTM C166 Standard Test Method for Covering Capacity and Volume Change Upon Drying of Thermal Insulating Cement
ASTM C168 Standard Terminology Relating to Thermal Insulation*， 2022-05-01 Update
ASTM C177 Standard Test Method for Steady-State Heat Flux Measurements and Thermal Transmission Properties by Means of the Guarded-Hot-Plate Apparatus
ASTM C356 Standard Test Method for Linear Shrinkage of Preformed High-Temperature Thermal Insulation Subjected to Soaking Heat
ASTM C390 Standard Criteria for Sampling and Acceptance of Preformed Thermal Insulation Lots
ASTM C411 Standard Test Method for Hot-Surface Performance of High-Temperature Thermal Insulation
ASTM C518 Standard Test Method for Steady-State Thermal Transmission Properties by Means of the Heat Flow Meter Apparatus
ASTM E136 Standard Test Method for Behavior of Materials in a Vertical Tube Furnace at 750_oC

2019 ASTM C195-07(2019) Standard Specification for Mineral Fiber Thermal Insulating Cement
2007 ASTM C195-07(2013) Standard Specification for Mineral Fiber Thermal Insulating Cement
2007 ASTM C195-07 Standard Specification for Mineral Fiber Thermal Insulating Cement
2000 ASTM C195-00 Standard Specification for Mineral Fiber Thermal Insulating Cement