GB/T 21461.2-2008 Plastics.Ultra-high-molecular-weight polyethylene(PE-UHMW)moulding and extrusion materials.Part 2:Preparation of test specimens and determination of properties (English Version)
This part of GB/T 21461 specifies the methods for sample preparation and performance determination of ultra-high molecular weight polyethylene (PE-UHMW) molding and extrusion materials. This part also specifies the requirements for the pretreatment of the test material and the condition adjustment of the sample before the test. This section gives the methods and conditions for sample preparation and performance testing. This section lists the suitable and necessary properties and test methods for characterizing PE-UHMW molding and extrusion materials. These properties are selected from the general test methods specified in the GB/T 19467.1-2004 standard. This part specifies other test methods widely used or of special significance for PE-UHMW molding and extrusion materials, as well as the determination methods for the properties named in Part 1. In order to obtain reproducible and comparable test results, the specimen preparation and conditioning methods specified in this section, as well as the specified specimen dimensions and test procedures, should be used. Test data obtained with specimens prepared in different steps or with specimens of different dimensions may not be consistent.
GB/T 21461.2-2008 Referenced Document
GB/T 1033-1986 Test method for density and relative density of plastics
GB/T 1040.1-2006 Plastics.Determination of tensile properties.Part 1:General principles
GB/T 1040.2-2006 Plastics. Determination of tensile properties. Part 2: Test conditions for moulding and extrusion plastics
GB/T 1409-1988 Methods for the determination of the permittivity and dielectric dissipation factor of solid electrical insulating materials at power,audio and radio frequencies including metre wavelengths
GB/T 1410-1989 Methods of test for volume resistivity and surface resistivity of solid insulating materials
GB/T 1634.1-2004 Plastics-Determination of temperature of deflection under load-Part 1:General test method
GB/T 1634.2-2004 Plastics-Determination of temperature of deflection under load-Part 2:Plastics,ebonite and long-fibre-reinforced composites
GB/T 19466.3-2004 Plastics-Differential scanning calorimetry(DSC)-Part 3:Determination of temperature and enthalpy of melting and crystallization
GB/T 19467.1-2004 Plastics-Acquisition and presentation of comparable single-point data-Part 1:Moulding materials
GB/T 2918-1998 Plastics--Standard atmospheres for conditioning and testing
GB/T 4207-2003 Method for determining the comparative and the proof tracking indices of solid insulating materials under moist conditions
GB/T 9341-2000 Plastics--Determination of flexural properties
GB/T 9352-1988 Plastics--Compression moulding test specimens of thermoplastic materials
ISO 179-1:2000 Plastics - Determination of Charpy impact properties - Part 1: Non-instrumented impact test
ISO 62:1999 Plastics - Determination of water absorption
GB/T 21461.2-2008 history
2023GB/T 21461.2-2023 Plastic ultra-high molecular weight polyethylene (PE-UHMW) molding and extrusion materials Part 2: Specimen preparation and property determination
2008GB/T 21461.2-2008 Plastics.Ultra-high-molecular-weight polyethylene(PE-UHMW)moulding and extrusion materials.Part 2:Preparation of test specimens and determination of properties