ASTM D5628-18 PDF

Scope: 1.1 This test method covers the determination of the threshold value of impact-failure energy required to crack or break flat, rigid plastic specimens under various specified conditions of impact of a free-falling dart (tup), based on testing many specimens. 1.2 The values stated in SI units are to be regarded as the standard. The values in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific hazard statements are given in Section 8. NOTE 1—This test method and ISO 6603-1 are technically equivalent only when the test conditions and specimen geometry required for Geometry FE and the Bruceton Staircase method of calculation are used. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D5628-18 Referenced Document

ASTM D1600 Standard Terminology for Abbreviated Terms Relating to Plastics
ASTM D1709 Standard Test Methods for Impact Resistance of Plastic Film by the Free-Falling Dart Method
ASTM D2444 Standard Test Method for Determination of the Impact Resistance of Thermoplastic Pipe and Fittings by Means of a Tup (Falling Weight)
ASTM D3763 Standard Test Method for High Speed Puncture Properties of Plastics Using Load and Displacement Sensors*， 2023-11-01 Update
ASTM D4000 Standard Classification System for Specifying Plastic Materials*， 2023-03-15 Update
ASTM D5947 Standard Test Methods for Physical Dimensions of Solid Plastics Specimens
ASTM D618 Standard Practice for Conditioning Plastics for Testing*， 2021-07-15 Update
ASTM D6779 Standard Classification System for and Basis of Specification for Polyamide Molding and Extrusion Materials (PA)*， 2023-03-15 Update
ASTM D883 Standard Terminology Relating to Plastics*， 2024-02-01 Update
ASTM E691 Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ISO 291 Plastics - Standard atmospheres for conditioning and testing
ISO 6603-1 Plastics - Determination of puncture impact behaviour of rigid plastics - Part 1: Non-instrumented impact testing

2018 ASTM D5628-18 Standard Test Method for Impact Resistance of Flat, Rigid Plastic Specimens by Means of a Falling Dart (Tup or Falling Mass)
2010 ASTM D5628-10 Standard Test Method for Impact Resistance of Flat, Rigid Plastic Specimens by Means of a Falling Dart (Tup or Falling Mass)
2007 ASTM D5628-07 Standard Test Method for Impact Resistance of Flat, Rigid Plastic Specimens by Means of a Falling Dart (Tup or Falling Mass)
2006 ASTM D5628-06 Standard Test Method for Impact Resistance of Flat, Rigid Plastic Specimens by Means of a Falling Dart (Tup or Falling Mass)
1996 ASTM D5628-96(2001)e1 Standard Test Method for Impact Resistance of Flat, Rigid Plastic Specimens by Means of a Falling Dart (Tup or Falling Mass)
1996 ASTM D5628-96 Standard Test Method for Impact Resistance of Flat, Rigid Plastic Specimens by Means of a Falling Dart (Tup or Falling Mass)