SAE AMS2204D-1973
TOLERANCES Aluminum Alloy Standard Structural Shapes

Standard No.

SAE AMS2204D-1973

Release Date

1973

Published By

Society of Automotive Engineers (SAE)

Status

Be replaced

Replace By

SAE AMS2204E-1983

Latest

SAE AMS2204F-2011

Scope

This specification covers established manufacturing tolerances applicable to aluminum-base alloy standard structural shapes. Standard structural shapes are shapes in certain standard alloys, tempers, sizes, and sections such as angles, channels, Tees, Zees, I-Beams, and H-Beams commonly used for structural purposes. These tolerances apply to all conditions, unless otherwise noted. The term "excl" applies only to the higher figure of the specified range. Tolerances in U.S. conventional units are primary; tolerances in SI units are shown as the equivalent of the inch/foot/degree dimensions and are not to be construed as standard for product produced to SI dimensions.

SAE AMS2204D-1973 history

• 2011 SAE AMS2204F-2011 TOLERANCES Aluminum Alloy Standard Structural Shapes
• 1996 SAE AMS2204H-1996 Tolerances Aluminum Alloy Standard Structural Shapes
• 1994 SAE AMS2204G-1994 TOLERANCES Aluminum Alloy Standard Structural Shapes
• 1989 SAE AMS2204G-1989 Tolerances Aluminum Alloy Standard Structural Shapes
• 1983 SAE AMS2204E-1983 TOLERANCES Aluminum Alloy Standard Structural Shapes
• 1973 SAE AMS2204D-1973 TOLERANCES Aluminum Alloy Standard Structural Shapes
• 1966 SAE AMS2204C-1966 TOLERANCES Aluminum Rolled or Extruded Standard Structural Shapes
• 1964 SAE AMS2204B-1964 TOLERANCES Aluminum Rolled or Extruded Standard Structural Shapes
• 1960 SAE AMS2204A-1960 TOLERANCES Aluminum Rolled or Extruded Standard Structural Shapes
• 1960 SAE AMS2204-1960 TOLERANCES Aluminum Rolled or Extruded Standard Structural Shapes