SAE AMS2204E-1983
TOLERANCES Aluminum Alloy Standard Structural Shapes

Standard No.

SAE AMS2204E-1983

Release Date

1983

Published By

Society of Automotive Engineers (SAE)

Status

Be replaced 1989-01

Replace By

SAE AMS2204G-1989

Latest

SAE AMS2204F-2011

Scope

This specification covers established manufacturing tolerances applicable to aluminum alloy standard structural shapes ordered to inch/pound dimensions. Standard structural shapes are shapes in certain standard alloys, tempers, sizes, and sections such as angles, channels, Tees, Zees, I-Beams, and H-Beams commonly used for structural purposes. These tolerances apply to all conditions, unless otherwise noted. The term "excl" applies only to the higher figure of the specified range.

SAE AMS2204E-1983 history

• 2011 SAE AMS2204F-2011 TOLERANCES Aluminum Alloy Standard Structural Shapes
• 1996 SAE AMS2204H-1996 Tolerances Aluminum Alloy Standard Structural Shapes
• 1994 SAE AMS2204G-1994 TOLERANCES Aluminum Alloy Standard Structural Shapes
• 1989 SAE AMS2204G-1989 Tolerances Aluminum Alloy Standard Structural Shapes
• 1983 SAE AMS2204E-1983 TOLERANCES Aluminum Alloy Standard Structural Shapes
• 1973 SAE AMS2204D-1973 TOLERANCES Aluminum Alloy Standard Structural Shapes
• 1966 SAE AMS2204C-1966 TOLERANCES Aluminum Rolled or Extruded Standard Structural Shapes
• 1964 SAE AMS2204B-1964 TOLERANCES Aluminum Rolled or Extruded Standard Structural Shapes
• 1960 SAE AMS2204A-1960 TOLERANCES Aluminum Rolled or Extruded Standard Structural Shapes
• 1960 SAE AMS2204-1960 TOLERANCES Aluminum Rolled or Extruded Standard Structural Shapes