ASTM F736-17(2023)
Standard Test Method for Impact Resistance of Monolithic Polycarbonate Sheet by Means of a Falling Weight

Standard No.

ASTM F736-17(2023)

Release Date

2023

Published By

American Society for Testing and Materials (ASTM)

Latest

ASTM F736-17(2023)

Scope

1.1 This test method covers the determination of the energy required to initiate failure in monolithic polycarbonate sheet material under specified conditions of impact using a free falling weight. 1.2 Two specimen types are defined as follows: 1.2.1 Type A consists of a flat plate test specimen and employs a clamped ring support. 1.2.2 Type B consists of a simply supported three-point loaded beam specimen (Fig. 1) for use with material which can not be failed using the Type A specimen. For a maximum drop height of 6.096 m (20 ft) and a maximum drop weight of 22.68 kg (50 lb), virgin polycarbonate greater than 12.70 mm (1⁄2 in.) thick will require use of the Type B specimen. NOTE 1—See also ASTM Methods: D1709, D2444 and D3029. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3.1 Exception—The inch-pound units in parentheses are provided for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazard statement, See Section 7. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM F736-17(2023) Referenced Document

• ASTM D618 Standard Practice for Conditioning Plastics for Testing
• ASTM D790 Standard Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials*， 2024-04-22 Update

ASTM F736-17(2023) history

• 2023 ASTM F736-17(2023) Standard Test Method for Impact Resistance of Monolithic Polycarbonate Sheet by Means of a Falling Weight
• 2017 ASTM F736-17 Standard Test Method for Impact Resistance of Monolithic Polycarbonate Sheet by Means of a Falling Weight
• 1995 ASTM F736-95(2011) Standard Test Method for Impact Resistance of Monolithic Polycarbonate Sheet by Means of a Falling Weight
• 1995 ASTM F736-95(2006) Standard Test Method for Impact Resistance of Monolithic Polycarbonate Sheet by Means of a Falling Weight
• 1995 ASTM F736-95(2001) Standard Test Method for Impact Resistance of Monolithic Polycarbonate Sheet by Means of a Falling Weight
• 2001 ASTM F736-95 Standard Test Method for Impact Resistance of Monolithic Polycarbonate Sheet by Means of a Falling Weight