ASTM D3139-19 PDF

Scope: 1.1 This specification covers the types of joints required for plastic pipe pressure systems with a wall thickness equal to or greater than that of SDR 64 and intended for use in supply and distribution lines for water, using flexible elastomeric seals. This specification covers the test requirements, test method, and materials. The test methods described are not intended to be routine quality control tests but are to evaluate the performance characteristics of the joint. 1.2 The text of this specification references notes, footnotes, and appendixes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification. 1.3 The following safety hazards caveat pertains to the test method portion, Section 6, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D3139-19 Referenced Document

ASTM D2837 Standard Test Method for Obtaining Hydrostatic Design Basis for Thermoplastic Pipe Materials
ASTM D618 Standard Practice for Conditioning Plastics for Testing*， 2021-07-15 Update
ASTM F477 Standard Specification for Elastomeric Seals (Gaskets) for Joining Plastic Pipe

2019 ASTM D3139-19 Standard Specification for Joints for Plastic Pressure Pipes Using Flexible Elastomeric Seals
1998 ASTM D3139-98(2011) Standard Specification for Joints for Plastic Pressure Pipes Using Flexible Elastomeric Seals
1998 ASTM D3139-98(2005) Standard Specification for Joints for Plastic Pressure Pipes Using Flexible Elastomeric Seals
1998 ASTM D3139-98 Standard Specification for Joints for Plastic Pressure Pipes Using Flexible Elastomeric Seals