SAE J1061-2008
Surface Discontinuities on General Application Bolts@ Screws@ and Studs

Standard No.

SAE J1061-2008

Release Date

2008

Published By

SAE - SAE International

Status

Be replaced 2012-11

Replace By

SAE J1061-2012

Latest

SAE J1061-2012

Scope

This SAE Recommended Practice defines@ illustrates@ and specifies allowable limits for various types of surface discontinuities that may occur during the manufacture and processing of bolts@ screws@ and studs in sizes through 24 mm or 1 in diameter inclusive with lengths to 150 mm or 6 in inclusive@ having specified minimum tensile strengths of 900 MPa or 120 000 psi and greater@ which are primarily intended for use in automotive assemblies. The recommended practice does not include inspection sampling requirements other than for referee purposes.

SAE J1061-2008 history

• 2012 SAE J1061-2012 Surface Discontinuities on General Application Bolts@ Screws@ and Studs
• 2008 SAE J1061-2008 Surface Discontinuities on General Application Bolts@ Screws@ and Studs
• 1998 SAE J1061-1998 Surface Discontinuities on General Application Bolts, Screws, and Studs
• 1992 SAE J1061-1992 SURFACE DISCONTINUITIES ON GENERAL APPLICATION BOLTS, SCREWS, AND STUDS
• 1975 SAE J1061A-1975 SURFACE DISCONTINUITIES ON GENERAL APPLICATION BOLTS, SCREWS, AND STUDS
• 1975 SAE J1061-1975 Surface Discontinuities on General Application Bolts, Screws, and Studs R(1998)
• 1973 SAE J1061-1973 SURFACE DISCONTINUITIES ON GENERAL APPLICATION BOLTS@ SCREWS@ AND STUDS