SAE J1061A-1975
SURFACE DISCONTINUITIES ON GENERAL APPLICATION BOLTS, SCREWS, AND STUDS

Standard No.

SAE J1061A-1975

Release Date

1975

Published By

Society of Automotive Engineers (SAE)

Status

Be replaced

Replace By

SAE J1061-1992

Latest

SAE J1061-2012

Scope

This recommended practice defines, illustrates, and specifies allowable limits for various types of surface discontinuities that may occur during the manufacture and processing of bolts, screws, and studs in sizes through 24 mm or 1 in. diameter inclusive with lengths to 150 mm or 6 in. inclusive, having specified minimum tensile strengths of 900 MPa or 120,000 psi and greater, which are primarily intended for use in automotive assemblies.

SAE J1061A-1975 history

• 2012 SAE J1061-2012 Surface Discontinuities on General Application Bolts@ Screws@ and Studs
• 2008 SAE J1061-2008 Surface Discontinuities on General Application Bolts@ Screws@ and Studs
• 1998 SAE J1061-1998 Surface Discontinuities on General Application Bolts, Screws, and Studs
• 1992 SAE J1061-1992 SURFACE DISCONTINUITIES ON GENERAL APPLICATION BOLTS, SCREWS, AND STUDS
• 1975 SAE J1061A-1975 SURFACE DISCONTINUITIES ON GENERAL APPLICATION BOLTS, SCREWS, AND STUDS
• 1975 SAE J1061-1975 Surface Discontinuities on General Application Bolts, Screws, and Studs R(1998)
• 1973 SAE J1061-1973 SURFACE DISCONTINUITIES ON GENERAL APPLICATION BOLTS@ SCREWS@ AND STUDS