ASTM G133-22
Standard Test Method for Linearly Reciprocating Ball-on-Flat Sliding Wear
- Standard No.
- ASTM G133-22
- Release Date
- 2022
- Published By
- American Society for Testing and Materials (ASTM)
- Latest
- ASTM G133-22
- Scope
- 1.1 This test method covers laboratory procedures for determining the sliding wear of ceramics, metals, and other candidate wear-resistant materials using a linear, reciprocating ball-on-flat plane geometry. The direction of the relative motion between sliding surfaces reverses in a periodic fashion such that the sliding occurs back and forth and in a straight line. The principal quantities of interest are the wear volumes of the contacting ball and flat specimen materials; however, the coefficient of kinetic friction may also be measured using the method described. This test method encompasses both unlubricated and lubricated testing procedures. The scope of this test method does not include testing in corrosive or chemically aggressive environments or extremes of temperature and humidity. 1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
ASTM G133-22 Referenced Document
- ASTM E112 Standard Test Methods for Determining Average Grain Size
- ASTM E1181 Standard Test Methods for Characterizing Duplex Grain Sizes
- ASTM G115 Standard Guide for Measuring and Reporting Friction Coefficients
- ASTM G117 Standard Guide for Calculating and Reporting Measures of Precision Using Data from Interlaboratory Wear or Erosion Tests
- ASTM G118 Standard Guide for Recommended Format of Wear Test Data Suitable for Databases
- ASTM G40 Standard Terminology Relating to Wear and Erosion
- ASTM G99 Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus
ASTM G133-22 history
- 2022 ASTM G133-22 Standard Test Method for Linearly Reciprocating Ball-on-Flat Sliding Wear
- 2005 ASTM G133-05(2016) Standard Test Method for Linearly Reciprocating Ball-on-Flat Sliding Wear
- 2005 ASTM G133-05(2010) Standard Test Method for Linearly Reciprocating Ball-on-Flat Sliding Wear
- 2005 ASTM G133-05e1 Standard Test Method for Linearly Reciprocating Ball-on-Flat Sliding Wear
- 2005 ASTM G133-05 Standard Test Method for Linearly Reciprocating Ball-on-Flat Sliding Wear
- 2002 ASTM G133-02 Standard Test Method for Linearly Reciprocating Ball-on-Flat Sliding Wear
- 1995 ASTM G133-95(2002)e1 Standard Test Method for Linearly Reciprocating Ball-on-Flat Sliding Wear
- 1995 ASTM G133-95 Standard Test Method for Linearly Reciprocating Ball-on-Flat Sliding Wear
