ASTM G99-95a(2000)e1
Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus

Standard No.

ASTM G99-95a(2000)e1

Release Date

1995

Published By

American Society for Testing and Materials (ASTM)

Status

Be replaced

Replace By

ASTM G99-03

Latest

ASTM G99-23

Scope

1.1 This test method describes a laboratory procedure for determining the wear of materials during sliding using a pin-on-disk apparatus. Materials are tested in pairs under nominally non-abrasive conditions. The principal areas of experimental attention in using this type of apparatus to measure wear are described. The coefficient of friction may also be determined.

1.2 The values stated in SI units are to be regarded as standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ASTM G99-95a(2000)e1 history

• 2023 ASTM G99-23 Standard Test Method for Wear and Friction Testing with a Pin-on-Disk or Ball-on-Disk Apparatus
• 2017 ASTM G99-17 Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus
• 2005 ASTM G99-05(2016) Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus
• 2005 ASTM G99-05(2010) Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus
• 2005 ASTM G99-05 Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus
• 2004 ASTM G99-04a Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus
• 2004 ASTM G99-04 Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus
• 2003 ASTM G99-03 Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus
• 1995 ASTM G99-95a(2000)e1 Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus