ASTM C1600/C1600M-19
Standard Specification for Rapid Hardening Hydraulic Cement

Standard No.
ASTM C1600/C1600M-19
Release Date
2019
Published By
American Society for Testing and Materials (ASTM)
Status
Replace By
ASTM C1600/C1600M-23
Latest
ASTM C1600/C1600M-23
Scope
1.1 This specification is for rapid hardening hydraulic cements. This is a specification giving performance requirements. There are no restrictions on the composition of the cement or its constituents. 1.2 The specification classifies cements by type based on specific requirements for very early compressive strength development. 1.3 The values stated in either SI units or inch-pound units shall be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. 1.4 The text of this standard refers to notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) are not requirements of the standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (Warning—Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to skin and tissue upon prolonged exposure.2 ) 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM C1600/C1600M-19 Referenced Document

  • ASTM C1012/C1012M Standard Test Method for Length Change of Hydraulic-Cement Mortars Exposed to a Sulfate Solution*， 2024-04-01 Update
  • ASTM C1038/C1038M Standard Test Method for Expansion of Hydraulic Cementitious Material Mortar Bars Stored in Water*， 2024-04-01 Update
  • ASTM C109/C109M Standard Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or [50-mm] Cube Specimens)
  • ASTM C1107/C1107M Standard Specification for Packaged Dry, Hydraulic-Cement Grout (Nonshrink)*， 2020-02-01 Update
  • ASTM C114 Standard Test Methods for Chemical Analysis of Hydraulic Cement*， 2023-10-01 Update
  • ASTM C1437 Standard Test Method for Flow of Hydraulic Cement Mortar
  • ASTM C151/C151M Standard Test Method for Autoclave Expansion of Hydraulic Cement*， 2023-12-01 Update
  • ASTM C183/C183M Standard Practice for Sampling and the Amount of Testing of Hydraulic Cement*， 2023-06-01 Update
  • ASTM C186 Standard Test Method for Heat of Hydration of Hydraulic Cement
  • ASTM C191 Standard Test Method for Time of Setting of Hydraulic Cement by Vicat Needle
  • ASTM C219 Standard Terminology Relating to Hydraulic and Other Inorganic Cements*， 2024-04-01 Update
  • ASTM C441/C441M Standard Test Method for Effectiveness of Pozzolans or Ground Blast-Furnace Slag in Preventing Excessive Expansion of Concrete Due to the Alkali-Silica Reaction*， 2024-04-21 Update
  • ASTM C596 Standard Test Method for Drying Shrinkage of Mortar Containing Hydraulic Cement

ASTM C1600/C1600M-19 history

Standard Specification for Rapid Hardening Hydraulic Cement


Copyright ©2024 All Rights Reserved