ASTM G132-96(2018) PDF

Scope: 1.1 This test method covers a laboratory procedure for determining the wear resistance of a material when relative motion is caused between an abrasive cloth, paper, or plastic film and a contacting pin of the test material. The principal factors and conditions requiring attention when using this type of apparatus to measure wear are discussed. 1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM G132-96(2018) Referenced Document

ASTM A128/A128M Standard Specification for Steel Castings, Austenitic Manganese
ASTM A514/A514M Standard Specification for High-Yield- Strength, Quenched And Tempered Alloy Steel Plate, Suitable For Welding*， 2024-04-21 Update
ASTM E122 Standard Practice for Calculating Sample Size to Estimate, With a Specified Tolerable Error, the Average for Characteristic of a Lot or Process
ASTM E177 Standard Practice for Use of the Terms Precision and Bias in ASTM Test Methods
ASTM E691 Standard Practice for Conducting an Interlaboratory Study to Determine the Precision of a Test Method
ASTM F732 Standard Test Method for Wear Testing of Polymeric Materials Used in Total Joint Prostheses
ASTM G40 Standard Terminology Relating to Wear and Erosion
ASTM G99 Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus