ASTM D6644-01(2021) PDF

Scope: 1.1 This test method measures the resistance of the bridge of a sew-through button to a steadily increasing strain. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D6644-01(2021) Referenced Document

ASTM D5497 ASTM D5497-94с(2005)
ASTM D618 Standard Practice for Conditioning Plastics for Testing*， 2021-07-15 Update

2021 ASTM D6644-01(2021) Standard Test Method for Tension Strength of Sew-Through Flange Buttons
2001 ASTM D6644-01(2013) Standard Test Method for Tension Strength of Sew-Through Flange Buttons
2001 ASTM D6644-01(2007) Standard Test Method for Tension Strength of Sew-Through Flange Buttons
2001 ASTM D6644-01(2002) Standard Test Method for Tension Strength of Sew-Through Flange Buttons
2001 ASTM D6644-01 Standard Test Method for Tension Strength of Sew-Through Flange Buttons