ASTM D3748-14(2019) PDF

Scope: 1.1 This practice covers the basic test procedures for determination of the physical properties and reporting of data for high-density rigid cellular plastics. 1.2 The values stated in SI units are to be regarded as standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. NOTE 1—This standard and ISO 9054 address the same subject matter, but differ in technical content. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ASTM D3748-14(2019) Referenced Document

ASTM C177 Standard Test Method for Steady-State Heat Flux Measurements and Thermal Transmission Properties by Means of the Guarded-Hot-Plate Apparatus
ASTM C518 Standard Test Method for Steady-State Thermal Transmission Properties by Means of the Heat Flow Meter Apparatus
ASTM D149 Standard Test Method for Dielectric Breakdown Voltage and Dielectric Strength of Solid Electrical Insulating Materials at Commercial Power Frequencies
ASTM D1622/D1622M Standard Test Method for Apparent Density of Rigid Cellular Plastics*， 2024-04-21 Update
ASTM D570 Standard Test Method for Water Absorption of Plastics
ASTM D618 Standard Practice for Conditioning Plastics for Testing*， 2021-07-15 Update
ASTM D638 Standard Test Method for Tensile Properties of Plastics
ASTM D648 Standard Test Method for Deflection Temperature of Plastics Under Flexural Load in the Edgewise Position*， 2024-04-21 Update
ASTM D695 Standard Test Method for Compressive Properties of Rigid Plastics
ASTM D696 Standard Test Method for Coefficient of Linear Thermal Expansion of Plastics Between -30176C and 30176C With a Vitreous Silica Dilatometer
ASTM D790 Standard Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials*， 2024-04-21 Update
ASTM D883 Standard Terminology Relating to Plastics*， 2024-02-01 Update

2019 ASTM D3748-14(2019) Standard Practice for Evaluating High-Density Rigid Cellular Plastics
2014 ASTM D3748-14 Standard Practice for Evaluating High-Density Rigid Cellular Plastics
2009 ASTM D3748-09 Standard Practice for Evaluating High-Density Rigid Cellular Plastics
2003 ASTM D3748-03 Standard Practice for Evaluating High-Density Rigid Cellular Plastics
1998 ASTM D3748-98 Standard Practice for Evaluating High-Density Rigid Cellular Thermoplastics